Head Gaskets and Valve Covers
Daewoo Leganza
Toyota Land Cruiser

What is the torque settings for the head and camshafts on a 2001 Daewoo Leganza?

434445

Top Answer
User Avatar
Wiki User
2010-09-27 04:41:38
2010-09-27 04:41:38
The head bolt torque specs on a daewoo lanos with the 1.6 liter engine are

step 1 18ft lbs step 2 turn all bolts 70 degrees step 3 turn all bolts additional 70 degrees and step 4 turn all bolts 30 degrees that is what came straight from the torque manual

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

I need a picture of a leganza deawoo head bolt tightening patern

User Avatar

18 n.m 13 lb.ft for all models (sohc,dohc 2.0L & 2.2L)

User Avatar

18 ft lbs then with torque angle meter on wrench turn 90 degrees 3 times. Use new head bolts they are torque to yield

User Avatar

18 ft in sequence,then additional 90 degrees,then additional 90 degrees,then additional 90 degress

User Avatar

i need how much pression (torque) for head daewoo nubira 2001 2.0

User Avatar

it just puts the car in the lowest gear (2nd) In the hold the car will set of in second. mainly used to reduce torque to wheels to reduce wheel spin

User Avatar

torque settings for cylinder head bolts

User Avatar

You need to specify which torque settings. As with any vehicle, torque settings are specific to a particular part of the vehicle.The torque settings for the cylinder head will differ from the settings for the crankshaft bearings.

User Avatar

What is the cylinder head torque specs for a 2001 daewoo nubira 2.0 litre engine and what is the proper torque order

User Avatar

In four stages, 1st with a torque wrench then with an angular torque gauge. Note: when replacing the head gasket, you should replace the head bolts as well.25 n/m (18 lb/ft) + 70 degrees + 70 degrees + 50 degreesin my original daewoo manual says 25n/m +90 degrees+90 degrees+90 degrees daewoo nubira 2.0 2001

User Avatar

what are the torque settings for a1986 Nissan micra please.

User Avatar

Torque Setting for what?

User Avatar

torque settings for a vauxhall 1.7 td clinder head

User Avatar

main bearing bolt torque settings

User Avatar

The torque settings are very specific in this vehicle. You can find out more about them in your users manual.

User Avatar

hi, im re buiding a Holden 253 and im after the complete torque settings

User Avatar

what are cylinder head torque settings for a 2 tdi Nissan largo

User Avatar

what are the torque settings for a mitsubishi 4m51 engine

User Avatar

The torque settings are normally included on a sheet when buying the gasket set.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.