18 ft lbs then with torque angle meter on wrench turn 90 degrees 3 times. Use new head bolts they are torque to yield
I need a picture of a leganza deawoo head bolt tightening patern
18 n.m 13 lb.ft for all models (sohc,dohc 2.0L & 2.2L)
With a torque wrench that displays inch-pounds. Not too often foot-pounds. Or tighten with wrench or screwdriver until snug. Then move wires back and forth and tighten until snug again.
pounds of force Foot pounds or torque. Measured with a torque wrench.
18 ft in sequence,then additional 90 degrees,then additional 90 degrees,then additional 90 degress
In order to change the torque you will need to tighten the bolt on the exhaust side of the injector to fifty inch pounds. Tighten the drivers' side bolt to nine foot pounds.
Carefully tighten the bolts in a crisscross pattern to 45 inch pounds. Then re-tighten them to 83 inch pounds.
Torque settings daewoo espero cylinder
Tighten to 20 foot pounds. Do not overtighten.
The torque spec is 89 in-lbs not ft lbs. Tighten in sequence from the inside out.
The head bolt torque specs on a daewoo lanos with the 1.6 liter engine arestep 1 18ft lbs step 2 turn all bolts 70 degrees step 3 turn all bolts additional 70 degrees and step 4 turn all bolts 30 degrees that is what came straight from the torque manual
it just puts the car in the lowest gear (2nd) In the hold the car will set of in second. mainly used to reduce torque to wheels to reduce wheel spin