Want this question answered?
what is the torque settings on the big ends and conrods on the opel corsa 1.4 utility
what is the torque setting for big ends and main bearing on a 2.5tdi ford ranger
To make a cool design on stardoll, simply select the pieces of the outfit one likes. From there, place them in a way that one feels the outfit's design seems "cool".
what is the head bolt torque setting on daewoo matize
hi i am looking for the torque settings for a proton gen 2 cylinder head bolt and crank shaft bolts both big ends and main bearing bolts
torque settings for mains,big ends and cylinder head Opel Corsa 1.7diesel 2000
The tie rod torque bolt settings, on your 2000 Jeep grand Cherokee, is 70 pounds per square inch. The bolts should be torqued in 35 pound intervals.
Torque Settings Mains = 108NMBig Ends = 54NM + 90° +90°Flywheel = 122.5NMCylinder Head = 78 NM + 90° + 90°Valve SettingsExhaust = 0.40 mm - 0.50 mmIntake = 0.20 - 0.3 0mm
The head torque settings for a VW Polo 1.6 cylinder head are 40 newton meters with 2- 90 degree turns. Bolts should always be replaced. It is not recommended to reuse the bolts.
40 ft.lb.
Cyl head: 40-43 lbs/ft Mains: 30-36 lbs/ft Big Ends: 23-28 lbs/ft fly wheel: 47-54 lbs/ft
Just tighten them up pretty hard. Even the factory doesn't pay attention to a torque spec here.