0
DOHC cover is 89 in-lbs SOCH cover is 22 Ft-lbs
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
What is the torque specifications for a 1996 Toyota Camry 4-cylinder valve cover?
what is the torque specifications for a toyota camry 4-cylinder valve cover
Valve cover gasket on a 1996 Saturn twin-cam sl2?
.....what about it? There is one. Dealer has premolded ones also
What are the torque specs for the valve cover for a 1996 Nissan altima?
if engine is 2.4 liter twin cam, torque is 2 steps. step 1 starts center out torque is 35 inch pnds. step 2 repeat center out 65 to 90 inch pnds. this is for valve cover pan .
Where is the valve cover set for a 1996 Honda Accord?
Please restate the question. What are you talking about? Valve cover gaskets, valve cover, what? need a valve cover
1996 Toyota Camry valve cover gasket?
how do i remove the valve cover to change the gasket in a toyota camry 1996
How do you install cylinder head bolts on a 1996 Saturn?
What are the torque specifications and the tightening sequence of the cylinder head bolts on a 1996 Saturn SL1?
Picture of theEGR valve in a 1996 Saturn?
see saturnfans.com
Where is the PCV valve on a 1996 ranger 4.0?
On a 1996 Ford Ranger , 4.0 : The PCV valve is on top of the drivers side engine valve cover , near the rear of the valve cover
How do you change valve cover 1996 Saturn sl2?
First you loosen 11 Bolts with a 10mm socket,after you take out the sparkplug boots,Gently pry up cover with a flat head screwdriver,your done!
Where is the pcv valve on a 1996 Saturn SL1 and how do you replace it?
I have an SL2 and the it is part of the valve cover. Small 1/2" hose comes from air box and goes to it on the valve cover. If you purchased your new one it might also help you locating it. It is located on the valve cover next to the oil cap just pull it out with some moderate force and pull the hose off by twisting it.
Where is the PCV valve on 1996 Infiniti i30?
on the right side of the valve cover
How do you pull out egr valve 0n 1996 Camry?
I haven't looked at a 1996, but it probably threads into the valve cover.
