answersLogoWhite
Crankcases and PCV Valves
Dodge Dakota
Saturn S-Series
Nissan Altima

Where is the pcv valve on a 1996 Saturn SL1 and how do you replace it?

9899100

Top Answer
User Avatar
Wiki User
2015-07-17 17:48:27
2015-07-17 17:48:27

I have an SL2 and the it is part of the valve cover. Small 1/2" hose comes from air box and goes to it on the valve cover. If you purchased your new one it might also help you locating it.

It is located on the valve cover next to the oil cap just pull it out with some moderate force and pull the hose off by twisting it.

1

Related Questions

User Avatar

You replace the valve seals on a 1996 Saturn SL1 by removing all of the hardware to get to the valves, unseating them, cleaning them, and sliding the new valve gaskets on. In order to do this you should consider getting a good Chiltons or other repair manual for your make, model, year, and engine.

User Avatar

timing for spark plug wires for saturn sl1 1996

User Avatar

How can I replace the headlamp on a 2000 Saturn SL1

User Avatar

The Saturn EGR valve is attached to the head, directly above the transmission bell housing.

User Avatar

The EGR valve is located on the drivers side of the head, just above the transmission bell housing. Remove the electrical and vacuum connections, then remove the two bolts that hold the EGR valve to the head. Use a NEW gasket when replacing the EGR valve.

User Avatar

It is just to the right attached to the head.

User Avatar

What are the torque specifications and the tightening sequence of the cylinder head bolts on a 1996 Saturn SL1?

User Avatar

Ok, the fuel pump is mounted in the fuel tank.

User Avatar

The idle is controls ONLY by the PCM. Replace your ECTS along with cleaning the Idle Air Control valve located on the throttle body.

User Avatar

Check your belt. That's most likely where its coming from

User Avatar

Top right side of engine as you stand in front of the car

User Avatar

Need instructions on how to replace a manual window regulator on drivers side on 1995 saturn

User Avatar

The module is in the dist. Simply remove and reinstall it.

User Avatar

this site has pics alsohttp://www.autozone.com/az/cds/en_us/0900823d/80/19/a5/ca/0900823d8019a5ca/repairInfoPages.htm

User Avatar

It's like repairing any other vehicle; you must first figure out what's wrong, find out which component has failed and either repair or replace it.

User Avatar

Under tha car at the r/r of the engine.

User Avatar

Where the dipstick goes in underneath the battery tray.

User Avatar

Valve guides or seals could be worn allowing oil to build up and be sucked in to combustion chamber

User Avatar

http://youtube.com/watch?v=AX-rtsyigaQ

User Avatar

1100 at the dealer. expect 800 at a local mechanic

User Avatar

When you here a rattling noise from the engine at idle.

User Avatar

The EGR valve is attached directly to the head, on the drivers side. It's a round device that is bolted to the head. It's relatively simple to remove, just disconnect any wiring (there should be plugs) then remove the bolts.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.