Want this question answered?
The 2003 Pontiac Grand Prix wheel bearing nut torque specification is 40 pounds. Do not exceed the 40 pound specification or you will risk causing the wheel seal to fail.
The 1997 Ford F2 50 pickup truck wheel bearing torque specification is 60 pounds. Over torquing the wheel bearing will cause it to fail.
100 Ft. Lbs
81 ft.lbs.
Assuming you are asking what the torque specification is for a lugs nut on that year Honda ... it would be 80 ft-lbs.
Make sure all the wheel bolts are installed correctly and tighten them to the correct torque specification.
The 2000 Ford Explorer front hub nut has a torque specification of 140 pounds of pressure. The hub should not be over tighten. Over tightening can ruin the seal.
The lug nut torque specification for a 2002 Sunfire is 90 foot pounds. This is assuming that the rims are factory stocked, as rims with different masses may require different torque settings.
Neukin Says: 105-112 ft-lb for a manual trans.. flywheel to crank
According to Chilton's Auto Repair Manual, 180 ft.lbs.
Wheel bearing nuts don't have a torque specification as the viscosity of the lubricant varies enough so the torque number would be nonsense... Practice has been to snug up the covering nut as tight as possible by standard foot long wrench, so the wheel fails to turn. Then back off 1/8 to 1/4 turn, allowing the wheel to spin or turn with light pressure.. hope this help / rtd
wheel nut torque 2005 impala