Want this question answered?
Front caliper mounting bracket bolts torque to 57ft-lbs Front caliper pin bolts torque to 27ft.lbs Rear Caliper mounting bracket bolts torque to 38ft-lbs Rear caliper pins torque to 15ft-lbs
Front caliper bolts 25 ft/lb Mounting bracket bolts 80ft/lb
Torque specs for brake caliper bolts 2005 mazda 6
32ftlbs for the pin bolts
The caliper mounting bolts, both in the front and in the rear, require 39N-m, or 28.9 ft-lbs of torque.
For the Chevrolet S-10 model years from 1982 to 1993, the torque for the caliper mounting bolts is 37 ft. lbs. The torque setting for the brake hose-to-caliper bolt is 32 ft. lbs.
33- Ft lbs.
75 ft lbs
18-25 ft lbs.
70 ft lbs
155 ft. lbs. They are stretch bolts so you SHOULD replace them everytime.
not sure from your question which caliper bolts you mean. the caliper to mounting braket bolt is 63 foot-pounds (these are the two bolts per caliper that you remove to change the pads. They are a pin and pass through a rubber boot). caliper mounting bracket to suspension is 137 foot-pounds (these are the two bolts per bracket that you also remove if you are changing the rotor disk). the factory uses red loctite on them and they are a bear to get out.