Want this question answered?
what is the color order of the wires to a Pontiac Sunbird ignition module
what is the wiring position for the ignition module on a 1990 Buick Park Avenue?
chiltons manual has wiring diagrams for that
Begin by removing the wiring harness from your 1998 Chevrolet Suburban ignition module. Remove the ignition module retaining screws. Reverse the process to install your new ignition module.
Here is the wiring diagram:
goto-installdr.com
Remove the ignition module retaining ring. Pull the ignition barrel out. Remove the wiring harness from the back of the ignition barrel. Reverse the process to install the new ignition module.
It depends on the engine. If it is a 3.3 v6, you will locate it under the 3 ignition coils. Unbolt each coil, 2 screws per coil, and the unit will be free, other than the primary wiring harness. The primary wiring harness is connected by a bolt, through the connector and into the module.
In your owner's manual you can find a wiring diagram for your ignition coil in your?æ1986 Pontiac. If you no longer have your owner's manual, contact Pontiac and they can send you a new one.?æ
Remove the wiring harness from your 1995 Chevy Blazer ignition control module. Remove the ignition control module retaining screws. Reverse the process to install your new ignition control module.
the ignition module is in front of the lft front wheel,inside the fender. the module wiring harness runs thrue a hole /gromet in the fender into the engine compartment just in front of te ignition coil.
The electronic ignition control module on an automobile is installed by first locating the unit at the top of the engine. The wiring harness is then disconnected from the original unit an a new module put in its place.