0
The ratio of vorticity to mass density.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
What happens if you put to much transmission fluid?
The fluid level will make contact with the rotating parts and whip the fluid with air into a froth. The aerated fluid will not be able to do its job and cause damage.
What is the definition of rotating unions?
Rotating unions are joints that are used for the transfer of air, steam, water, hot oil, hydraulic fluid and industrial gas. They come in a wide range of sizes and shapes.
What has the author Edward Charles Deverson written?
Edward Charles Deverson has written: 'The performance of an aerofoil in stationary and rotating cascades' -- subject(s): Cascades (Fluid dynamics), Fluid dynamics, Turbomachines
What is eddy theory?
rotating mass is more understood than in laplace's time. produce whirlpools at rapidly spinning fluid mass.
Can overfilling transmission with fluid cause dammage?
Not usually. It will force the excess past the seals where the drive shaft or CV axles go into the transmission. If the fluid level reaches any rotating parts, the fluid may foam up and will hamper its lubrication abilities.
What has the author W David Morris written?
W. David Morris has written: 'Heat transfer and fluid flow in rotating coolant channels' -- subject(s): Cooling, Fluid dynamics, Heat, Transmission, Turbomachines
What is a hydraulic slip ring?
Hydraulic slip rings are similar to electrical slip rings and transmit fluid power from a stationary source to rotating parts. The hydraulic slip rings are also known as Fluid Rotary Unions (FRU). Fluid pressure is connected from a stationary tube (the stator) to the rotating parts through either single or multi-ported rotating component (rotor) of the slip ring. Multiple application combined slip rings are also wide used to transport not only hydraulic power but also electrical as well as communication cables through a combined slip ring.
What has the author Niel P Nielsen written?
Niel P. Nielsen has written: 'Flow through a rotating fluid' -- subject(s): Naval architecture
What is a pool impeller?
An impeller is a rotating device that is used to force a fluid in a desired direction under pressure. A pool impeller is one of these devices, but in use in a pool.
Which loss is not common between a transformer and rotating machines?
Frictional , rotating losses are not common to transformers and rotating machines. these are specific to rotating machines.
Is a thrown Frisbee rotating or revolving?
rotating
What are rotary couplings used for?
Rotary couplings is a mechanism used to move fluid that is under pressure from a static inlet to a rotating inlet. They can be bought at sites like DSTI and Amazon.
