what is the fifference between a saturn sw1 and sw2
Yes, it should be perfectly fine to use ATF4 on your 1998 Saturn wagon.
Yes, the front ends should be identical.
See link below
What kind of cylinder?
uses the same as the front
Both are 6.5"
GM vehicles are not equipped with an inertia switch.
use thwe seek & tune keys (up down or horizontally back & forth) to change the #s displayed until correct code is achieved.
pressure in the fuel tank with out a vented gas cap
An auto thermostat is strictly a mechanical device, so no.
I have a problem with a 2000 LW1 saturn. It's an intermittent problem. Ocassionally will not start until today. Today the car had to be towed, it would crank over but not start. The crank position sensor and control module have been changed. The problem is still there. The fuel pressure is at 55 (between 50 and 60) so that rules out fuel pump and fuel filter. Not sure if it is getting spark. I used a spark tester and it didn't look like it was getting a spark. I was told it may be a temp sensor? Not sure what to look at next! Please help!! Don W Michigan
it will be mounted at the harmonic balancer on the bottom and front of the engine
There is a screw-in plug on the side of the transmission. Saturn transmissions do not have a dipstick since they are supposed to be a "sealed" unit.
These cars don't use a crank sensor - the ignition module watches the electrical properties of the #4 cylinder spark plug and uses that to calculate where the engine is within the mechanical rotation. If you are having troubles, verify/replace that spark plug and the wiring. In a past experience with this car, it turned out to be the ignition module, located under the coil packs.
I thought the fuse diagram was on the back side of the fuse panel cover.
it will work if you pray hard enough
The knock sensor is on the left side of the block below the exhaust manifold.
The crank sensor is located approximately on the top front center of the engine block, behind the crank pulley, in the area below your alternator. It is secured by a single bolt and the wire runs beneath the intake manifold.
In 1997 Camry and Corolla makes did not offer a wagon body style.
A wheelwright makes metal rimmed wooden wagon wheels.
Yea, very dependable vehicle if u keep it maintained!!
In front of the wheel well, just the other side of the drivers feet.
Station Wagon, Sedan, Sports Car, Updated answer: I interpreted the question differently and came up with: Skoda Subaru Suzuki Saab Studebaker Saturn These would be different makes of vehicles.