It is an Electric Blower, And it senses that the vehicle is still very warm, so it keeps running to cool the engine -Mr. Mechanic-
Could also be the blower motor resistor if it wont turn off at all
The bearings are out of it. Replace Blower motor.
2001 buick lesabr // when recirculate speed doesnt change only make humming sound rest of heater works fine
Licking involves using the tongue to contact a surface, while blowing involves expelling air through the mouth. Licking is a form of tasting or exploring with the tongue, while blowing is typically used to produce sound or move objects.
could be a fuse, a relay, the blower motor or the blower resistor. It's easy to check the fuse, using the owners manual. I am not sure where the relay is, and it requires special tools or replacement with a known good relay to test. If the blower works on high and no other speed, then the resistor is bad. If fuse and relay are good, and blower does not work in any position, suspect the blower motor itself.
If the compressor is running, the blower is blowing, and there's no cold air, you need freon. If the whining is from under the hood, the compressor may be damaged. That's what happens when running without freon.
it sounds like the compressor drive belt is loose under the hood.or the noise may be the blower motor{blower that pushes air into your car} rule blower motor out by using fan in heat mode. Or maybe a bearing in the clutch has gone out.
blowing air gives more oxygen so it makes the fire bigger
Well if it is your fan regardless of ac or not it would probably be the blower motor resistor. I had the same problem the part fixed everything it is about $35 for the part if you are able to do it yourself.
Blower motor should be located at the passenger's side firewall Remove wiring harness Remove air intake line Remove 3-4 screws Remove and replace blower motor
when you turn on blower it makes a strong odor of burning rubber.
I do
If you have the A/C turned on the cooling fan will run continuously which is normal. If that is not the case then the thermal relay may be stuck shut.