the hole dash panel.
The wiring harness for the radio in a 1991 GMC Pickup is going to be behind the radio. The wiring harness is plugged into the back of the radio. The fuse for the radio is in the fuse box located on the driver's side below the dashboard.
Remove the retaining cover from your 1994 Chevy S 10 pickup truck radio. Remove the radio retaining bolts. Slide the radio out. Remove the wiring harness and the antenna cable from the back of the radio.
In my 2000 Toyota Corolla CE fuse for the radio is located at the back side of the radio, you need to pull out the radio and you will see the fuse on the back side of it between wires
above the oil filter to the back alittle
I own a 92' Toyota pickup and i recently changed the fuel filter. It sat down between the block and the intake manifold on the back near the firewall. Check there.
To remove the radio in a 1995 Toyota Corolla, first pry the radio frame from the dashboard using a flat tool like a screwdriver. Then, press in on the pins at each side of the radio and slide it out of the dashboard. Remove the wires from the back of the radio.
Remove the dash and remove the instrument cluster, the lights are in the back of the cluster.
Freeze Out plug, cracked block or waterjacket.
Begin by removing the retaining ring at the top of your 1986 Toyota pickup truck ignition switch. The ignition switch will slide out. Remove the wiring harness from the back of the ignition switch.
First off it is not a Toyota but is instead a Nissan. Of course it is fake and they do not even claim it is real.
You will have to remove the cover then the radio it self. I believe that the fender needs to come off to replace the base & mast on that model.(I could be mistaken) Then youll need to feed the wire back from the fender to the radio. Put it all back together, but make sure you get the fender in alignment so it doesn't catch the door. I hope i was some help, sorry if i was not.
passenger side up under the bed right in front of the back rear tire.