Oil and Oil Filters
Ford Expedition XLT
Ford F-250
Toyota Trucks and SUVs

Where is the oil sending unit on a 1989 Toyota pickup V6?

555657

Top Answer
User Avatar
Wiki User
Answered
2005-04-04 02:52:17
2005-04-04 02:52:17

above the oil filter to the back alittle

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


Which sending unit? Oil pressure sending unit? Engine temp sending unit? Fuel gauge sending unit?

Just to the left of the Oil filter towards the front of the engine.

The 1989 Pontiac Firebird oil sending unit is located on the bottom of the engine. You will need to remove the oil pan in order to access the oil sending unit.

In the fuel tank. Fuel tank must be removed to gain access to the sending unit.

Where is the coolant temperature sending unit in a 96 toyota tacoma 3.4L V6

Any fuel sending unit I've ever seen is mounted into the fuel tank.

If it's not located on the thermostat housing, where the top radiator hose attaches to the motor, then it's under the intake air chamber in the head.

The oil sending unit is located on the back of the block, directly behind/below the distributor.

It is right behind the distributor.

Directly under the oil filter with a wire hooked to it. Then the wire hooks to the wire harness with another connector.

it is with the fuel sending unit and is in series with the circuit that powers and measures the resistance on the sending unit via the float on the sending unit.

With a 4.3L engine, the oil pressure sending unit is in the back of the engine just to the drivers side of the distributor.

if its a full size pickup, with a v8, the fuel pressure regulator is in the tank, its part of the sending unit

The temperature gauge sending unit, located on a 1989 Honda Accord LXI is located on the thermostat. It is the small connection with a single wire sticking out of it.

It is in the back of the engine near the distributor

it is located behind the distributor on top of the block there is the oil sending unit and a oil sending switch with a wire that goes to your choke if it is electric trace it back and you will find it...

The water temperature sending unit is on the front of the engine. It is next to the top water hose inlet connection.

The 1991 Chevrolet S 10 pickup truck oil sending unit is located on the bottom of the engine, in the oil pan. You will need to remove the oil pan in order to access the oil sending unit.

it is on the passenger side of the motor below the intake manifold. If you look through the right front wheel well above the tire you will be able to spot it near the oil filter.

just above and to the rear of the oil filter


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.