$500
You are extremely fortunate. The 4 cylinder & V6 on the 2000 Mazda 626 are NOT interference engines. There should be no damage.You are extremely fortunate. The 4 cylinder & V6 on the 2000 Mazda 626 are NOT interference engines. There should be no damage.
The thrust bearings are inside the engine. You must remove crankshaft to replace them.
it is connected to the back of the push button panel. you have to remove the portion of the dash that the push buttons are in to access the amp. there are 2 screws, one each on either side of the steering column. pop off the black plastic bezels, and pop off the dash lite rheostat. underneath are the screws. then, gently pry off the dash part. i start at the glovebox. you will then have to disconnect the wiring harness' to the a/c amplifier. all the controls/amp are then accessible from the back
For a 2000 Mazda 626, the spark plugs are located underneath the engine manifold. In order to remove these, you must first remove the spark plug wire boots by turning upward in a left to right motion. Afterward, use an insulated spark plug socket, extention and driver to remove the spark plugs are they are inches beneath the manifold. Be sure to properly gap the spark plugs, use anti-seize compound, and properly re-attach the spark plug wire boots.
how to change speedometer sensor on mazda millenia 2000 2.3 v6
The Mazda millenia from 2000 gets 20 mpg, 28 on the highway, and 25 on average.
bottom
a Mazda millenia with a miller cycl engine 2.3 engine has 6 igition coils
millenia starting with my 2001 had cabin filters. 2000 my and before no hava
Button on the shifter.
air conditioning
It depends on what model of Mazda you have. My 2000 Mazda millenia doesn't. It does have reverse teeth though. I would have to go to a dealer to get another one made for it.
in the fuel tank. you gotta drop the tank
po421 is catalytic converter problem rear bank
check the main fusible link
it's in the trunk, under the carpeting, near the back in the centre.