answersLogoWhite

0


Best Answer

The lower the amperage, the deeper the charge, but also the longer it takes. Use the 2 amp if you have the time.

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What setting do you use to charge your ATV 10 or 2 amps?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

When charging a car battery what amps should it be at?

It depends on how long you can let it sit before you need to use it. If you have 8 to 10 hours then a setting of 2 amps is appropriate. For a quicker charge then 12 to 20 amps is recommended.


Can you charge an ATV battery with a car charger?

No because an ATV battery only can take 2 amps and a car charger pushes out 6 to ten But you can use a float charger there perfectly safe. it depends on your charger. most chargers have several amp settings to choose from. mine has settings for 2, 10, 25, 40, and 200 amps for jump starting. as long as you make sure the volts, 6 or 12, are right it will charge it.


How much does Goodyear charge for ATV tires?

Goodyear charges around 80 - 90$ depending on what kind of atv you use. More powerful atv's use better tires than smaller ones. So, if you have an average atv I would say around 85$ for the tires


What amps should you use to charge a Chevy hhr 2008?

From 5 to 15 amp charger.


Can I Use portable 12v 1200amps charger for 375 A garden tractor battery?

Only if the voltage is the same (12v battery and 12v charge) and there is a lower amperage setting on the charger like around 10, maybe 30 but for small batteries 30 amps is a lot of current and they may get to be too hot warping plates, boiling acid away, and melting the case! 1200 amps... yeah, that's WAY too much. Don't use that setting!


Can you use 2 amp charger to charge a 3 amp device?

If the device can be recharged it must have a rechargeable battery. Charging it at 2 amps instead of 3 amps would mean it takes 50% longer to charge.


How do you check for amps?

You need to use an ammeter - usually the current setting on a multi-meter. The meter should be connected to the circuit in series.


Can you use a 12 amp charger to charge 6 amp battery?

You can charge a 12 volt battery with a 6 AMP charger. The amount of amps put out by the charger is actually the rate which the power flows out from the charger, not the amount of volts it will charge. Volts and Amps are two different things. You can't charge up a 12 volt battery all the way, using a 6 volt charger. You can charge a 12 volt battery with a 12 volt charger rated at '6 amps'. It will charge the battery faster than a 2 amp charger will, but it will take longer than using a 12 amp charger. You probably don't want to use anything higher than a 12-16 amp charger for charging a 12 volt battery. Some chargers are equipped with a 60amp boost charge that is used for starting the vehicle, without having much of a charge in the battery. You DO NOT want to attempt charging a battery with it set to a 60amp boost charge. That is for starting vehicles only and could damage your battery. Keep in mind that the lower the amps are, that you use to charge the battery (1-2amps), will result in the charge lasting longer without recharging it, than if it was charged up at a higher setting (12-16amps).


Does Orbitzcom charge you to use their website?

I went to the Orbitz website and seen where you need to register. They do not charge to use the site. As far as I can tell without setting up an account I don't see a charge.


How do you charge a battery on 1300 vtx?

Use a battery charger with a 2amp charge. Takes a few days. These small batteries don't like to be charged too fast with high amps.


Can i use a home charger that has 3to 12V300mA output to charge my car battery at home?

No. The charger for a car battery has an output measured in amps. You have an output measured in milliamps. There are 1000 milliamps to 1 amp. Way too small.


How do you start an ATV that makes a clicking noise?

charge the battery, change the battery, use the back up start either a pull start or kick start.