If you're talking about your pool filter, it should be set to filter or run. Use the bypass or recirculate setting if you wish to circulate the water without having the water pass through the filter. Use the backwash setting to clean the filter.
pull the filter out and hose it off, replace the filter, if you vaccum your pool more frequently it should help keep the filter cleaner
The setting of the sand filter should be on filter for a normal vacuum. However if you are getting rid of the results of using clarifier from the bottom of the pool you would be beter of vacuuming to waste.
Filter or circulation with pump running add chemicals.
Technically, you don't backwash the pool, you backwash the filter. This is assuming you have a sand or DE filter. The filter valve should have a backwash setting. Turn off the pump, set the filter to backwash, and turn on the pump unitl the water runs reasonably clear.
It should be inside the air cleaner housing.
The "Rinse" will also take water out, but you should really have a waste setting. Call a local pool company or the maker of your filter system.
You should ALWAYS use an air cleaner on any vehicle. The filter prevents contaminates from entering the fuel and combustion system.
you should clean it at least once a month because it can get damaged if you don't. your water will also be cleaner.
about an inch below the TOP of the filter...there should be a line on your filter...
Ideally none! You will always get a bit in there from people bringing it in on their feet, and from the wind blowing in in but you should try to keep it well-vacuumed so that the water stays cleaner and so that your filter will last longer.
You can either buy filter cleaner or use gas, either way they will both clean the filter. You will need a 5 gallon bucket or a large plastic bag. It is best to clean several filters at once, because it is a dirty job. Fill the bucket with a little bit of gas or cleaner and place the filters in. Soak the filter in the cleaner for about five mins. Then carefully squeeze the excess liquid and dirt from the filter. Be careful not to tear the filter. Repeat if necessary. Allow the filter(s) to dry then soak them with filter oil. A good air filter should last through several cleanings.
Always run the pump in filter, for atleast 4 to 5 hrs a day , never run the pump in anything else but filter , only time you change filter setting is when you back wash you filter, also when you ope your pool and shock it for the 1st time run the filter over night then back wash next day
YES it should be no problem
You could,When it's warmer.
Generally, that should not be a problem.
It should be on filter and don't forget to backwash at least once a week.
Just keep the setting on filter you may find that the preasure increases and if it does just give it a quick backwash to reduce it if needed.
Just enough so that the skimmer is above the water and the pipes to the filter and filter can be drained.
change the spark plugs and wires and change the oil and change the oil filter and air cleaner filter and you should get better gas miles
If you vacuum cleaner is using a three blade plug (cap) on the cord you should not be getting static discharges from it. Make sure that the receptacle you connect to is grounded and that the ground is connected to the body of the cleaner.
It should be in the tubing in the air filter running into the throttle body. They are usually after the air cleaner.
That all depends on the size of the filter. It should say how many pounds of sand you need on the side of your sand filter.
if you have checked the plugs air filter fuel filter oil and oil filter the next thing that you should look at probably should be the injectors they could be clogged with "gunk" from low grade or low quality gas the gas quality is lower in the winter than in the summer even if it is a carbourated fuel system it will still have a form of injector. try fuel injector cleaner if that doesnt work then you may have to clean them by hand
That's quite possible. A filter, or filter change should do the trick.