we took a hammer to mine lol didnt have a wrench to fit it we was turboin my 95 gti vr6 and put the oil line at the plug on the bootom of the oil filter cap went for bout a month and i hit a speed bump and ripped it out...................just beat it out with somethin
I need to know
a wrench with a metal band that wraps around oil filter that ables you to turn aka an oil filter wrench
any oil filter wrench - it warps around the filter and you can adjust it - the wrench looks like a giant ring
In order to remove the oil filter from a 2007 Toyota RAV4 you need to use an oil filter wrench. This wrench is a specialty to Toyota.
You need a special wrench from your auto parts store.Slide the wrenchup into the fuel line on either side of the filter.You need to turn the wrench and push toward the filter on either side. The wrench pushes back mini clamps that grab the flange on each filter end.You do not need the wrench to replace the filter.
you need a torx bit
No..maybe a oil filter wrench to remove it, but, install it by hand (HAND TIGHT)
You will need to remove the gas tank from your 2004 VW Passat in order to change the fuel filter. Remove the gas line. Remove the fuel filter retaining plate. Reverse the process to install the new fuel filter.
you need to drop the transmisison oil pan,
No. 2008 highlander has a aluminum filter housing you need to remove with a special type of filter wrench. I was able to tap mine loose without a wrench but it could be at 24n-m tight which is difficult to loosen.
Just unscrew the filter. If you cannot remove it with your hands, it was put on too tight, which is common, as most people tighten them too much. You will need to use a good filter wrench. The type wrench you will need depends on how much room you have. Oil the gasket & Put the new filter back on and only tighten it 3/4 turn after the filter makes contact with the mounting surface. By doing this you will not need a filter wrench when removing the filter next time. 3/4 turn is plenty tight and any more is too much.Just unscrew the filter. If you cannot remove it with your hands, it was put on too tight, which is common, as most people tighten them too much. You will need to use a good filter wrench. The type wrench you will need depends on how much room you have. Oil the gasket & Put the new filter back on and only tighten it 3/4 turn after the filter makes contact with the mounting surface. By doing this you will not need a filter wrench when removing the filter next time. 3/4 turn is plenty tight and any more is too much.
go to auto parts store and get the right filter for the Saturn then go to the filter wrench selection and find one that fits that is the style you like