Special bolts! Do not replace with generic will fit bolts! But the head size on my car is 18 MM
The shorter bolts go on the outside corners.
The 1996 Toyota Camry head bolt size is 5/8 by four inches. There will be eight head bolts in each head.
80Lbs for flywheel, 10 to 15lbs for pressure plate
torque for head bolts 3 size diferent and rods
there is 19mm socket
10mm
You will need a NEW set of 10 new head bolts ($40-45). They are supposed to be STRETCH bolts, and are therefore NOT to be reused. There is a bolt pattern. Torque three times at 58 foot pounds of torque. 20/22R/RE head bolts are not torque-to-yield (stretch), and are re-usable! Torque is 55-63 foot pounds. Thoroughly clean the bolts on a wire wheel and inspect for pitting, especially in the threads and replace as necessary. It is also recommended to re-torque them after about 1,000 miles. following the torque pattern, one at a time, loosen the bolt the least amount possible, and then turn to torque spec - 55-63, although many of us who do this regularly go to 70. Oh - and don't forget the "11th head bolt" buried in the pool of oil below the distributor gear, but it should only be torqued to about 14 foot pounds.
The 2002 Kia Rio head bolts can be removed with a 12 pointed 12mm socket
10mm 12-point socket
The lug bolts on a 1996 VW Golf is a M14 x 1.5 thread, with a 17mm hex head.
Are you sure of the engine size? Should be 7mge inline six cyl. 22r wasn't offered in a 1990 cressida.