3/8 by 3inch grade 8
The motor mount bolt size for a 1996 Windstar 3.8 is cross-thread a 3/8" bolt. That is the only bolts that will fit.
it is the same size of the bolt same as the hole and thread. the higher the grade of the bolt the more touque you can apply.
The upper engine mount is on the passenger side of the vehicle right in the middle of the engine. There are 5 bolts holding it on. The bolts are a size 15mm deep socket. Remove the two bolts on either side. Jack up the engine from the bottom, underneath the oil pan, using a piece of wood between the jack and pan. Now remove the 3 bolts holding the mount to the engine. Replace the mount. Screw 3 bolts back in. Lower the engine and screw the two side bolts back in.
form_title= Canoe Motor Mount form_header= Take your canoe wherever you go with a motor mount. How old is your car engine?*= _ [50] How far do you travel to canoe?*= _ [50] What is the size of your canoe?*= _ [50]
I read online on some forum that they are 8mmx25mm bolts and JD part number is 19m7867.
3/8-16
Most VW/Audit calipers are held by Torx bolts, not hex.
7/16 coarse i believe
The 2010 Volkswagen Jetta has a 2.5 L base engine size.
The 2003 Volkswagen Jetta has a 2.0 L base engine size.
The 2004 Volkswagen Jetta has a 2.0 L base engine size.
The 2001 Volkswagen Jetta has a 2.0 L base engine size.