0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What size screw do you use to mount a westinghouse 32 inch led tv?
A Westinghouse 32 inch TV should be mounted to the wall with a half inch screw. A larger screw can be used, if available.
Bolt size for Honda civic rear motor mount bolt?
What size bolt for a 2005 Honda civic DX power steering tank bracket..
What size bolt goes in the motor mount that bolts the bracket to it?
it is the same size of the bolt same as the hole and thread. the higher the grade of the bolt the more touque you can apply.
What are the Motor mount bolt sizes on a 96 windstar 3.8?
The motor mount bolt size for a 1996 Windstar 3.8 is cross-thread a 3/8" bolt. That is the only bolts that will fit.
What is the motor mount to block bolt size for a 350 Chevy?
3/8-16
What is the size of the bolt hole on a 302 ford motor mount?
7/16 coarse i believe
What is the bolt size on harley Davidson primary mount?
What is a primary mount? You have an inner primary, outer primary, inspection cover, and derby cover.
What size bolt is used on a 1990 Ford Probe front motor mount?
a two inch one
How do to remove a stripped motor mount bolt on a SSEI Bonneville?
Well your gonna have to have a new mount bolt. Drill it out so that the drill bit is the same size as the hole the bolt goes into. Snap the head off when you drill past thehead. The bolt should hand screw out. If not use vicegrips. Then put the new one in the same place. Should replace the mount aswell.
What bolt size to mount transmission to a Chevrolet 350?
3/8-16x1 1/4 Grade 8
What bolt size to mount chevy 350 transmission to a car?
It's usually 3/8-16 for the bell housing and 7/16-14 for the tailshaft mount.
What size bolt does a corolla motor mount take?
In most cases the Toyota Corolla motor mount bolt is a three-quarter inch by four inch long bolt. To be absolutely sure of the size of motor mount bolt you will need to know the year of your Toyota. +++ I don't know what the bolt screws into, or if it has a nut on it, but be aware that it may be metric (19mm dia X 100mm long being very close to 3/4" dia X 4" long) but not necessarily from the standard M-series or complementary metric fine-thread range. If it is a metric fastening the A/F size of the head will be in mm too, of course.
