That would depend on the make and model of car.
what size are the bolts that hold a starter on a 1995 f 250 powerstroke
Dime sized bolts.
If you are wondering about the thread size, they are the same as the Lug Bolts. 12x125 MM.
The bolts that hold the caliper in place on a 1997 Catera are 3/4 inch. The bolts that hold the caliper together are 7/16 inch. Probably the same hardware.
You need 54mm bore bolts for a caliper for a 1998 Chevy Prism.
1/2 or 13mm or 9/16 or 15mm I can not remember right now which. It will have three bolts that hold it on. That is for a Diesel starter.
the buckets will rotate. it is also likely that the rope will break, the buckets will fall, and the water will spill, mainly depending on the strength of the rope and size of the water-filled buckets
They should be the same diameter, but they may be of different lengths.
it depends on the size
Ok simple lift hood up and on the headlight assembly you'll see 3 bolts "10mm socket size" take them out and the headlight assembly will pull out far enough for you to reach the bulb sockets. Change them and do everything in reverse. It had me going at first also! RJ
Your local parts store should be able to help / answer that question.
I believe the entire headlight has to be removed to get to the back where you can twist out the old one and install the new one. there is 2 bolts holding it in and i believe they are either a 12 or 13mm bolt size, the bulb code should be a 9007 type. good luck