5L74 gates
the drive belt is 76 length 1.5 width
somewhere in the 44" size but best to look on the belt for a number or remove it and match it to a new belt. might also measure around around the pulleys with a small rope/string if you don't have a old belt to get the size of the belt.
The size of belt that fits a Quantom Pro Lawn mower will vary depending on the model of the mower. The belts can usually be bought in any hardware store or at retail stores such as Sears.
It depends on the Mower Deck you have. I have an LT166 with a Freedom 42" mulcher mower deck. To change the belt, I: 1) Lower the Mower Deck to the bottom position (on the lowest grass height) 2)Remove the front cotter pin and connector that locks the mower deck to the front of the tractor. The connector looks like a square loop with a tail. Slip the mower belt off the tractor (it should be loose and easy to do). 3)Remove the cotter pins that attach the lifter arms (on both sides) to the deck. 4)Remove the cotter pin that attach the blade brake to the tractor. Remove the blade brake shaft from the tractor (it should just slip off) 5) Raise the mower deck lever on the tractor -- the lifter arms should slide out from the mower deck. 6)Slide the mower deck out from under the tractor. 7) Remove the screws that hold the black plastic cover of the deck. 8) Find the spring tensioner on the side of the deck under the cover. Loosen the nut that keeps the spring tensioner tight, until the spring moves freely. 9) Loosen the nut on the FORWARD gear (the one the tensioner is connected to). That gear will then move so you can remove the belt. 10) Replace belt (Make sure the blades on the Freedom deck are aligned first!). Tighten spring tensioner. Tighten nut on forward belt gear. 11) Reverse steps 7,6,5,4,3,2,1
The 66 inch deck belt fits Murray 42 inch and 46 inch models 425303X92A, 425303X92B, 465305X92A, 465305X92B. The width is 11/16 inches. This belt size replaces Murray part numbers 37X112, 37X112MA.
1/2 x 88" Got one recently at Advance Auto for $17.00. Fits great. Good luck!
tractor supply has a key that fits...its less than 3 dollars
The correct one.
It is not like a belt and pulley. A timing belt is a belt and it fits on a pulley.
There is no such thing
having trouble with belt tention ?
The way it fits around and on top of the pulleys.