0
What size of shell can be used in a Riverside Arms Double Barrel Shotgun?
Wiki User
∙ 12y ago
Depends on what is marked on the gun.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
What type of modern shotgun shell can you use in a Fox double barrel shotgun model B-BSE for deer hunting?
Deer slugs are the shotgun shells to use when deer hunting.
Where is the breech of a shotgun located?
That is the rear end of the barrel where the shell is inserted.
What gauge shell do i use for your Browning semi automatic shotgun?
It will be marked on the barrel.
What is the shell length for a browning twelve gauge semi auto shotgun?
Should be marked on the barrel
Can you swap out a rifle barrel on your Baikal IZH 18 shotgun?
Generally, no. While single shot rifles MAY have the rifle barrel replaced with a shotgun barrel, reverse is not true (usually) A rifle cartridge generates much higher pressures than a shotgun shell.
Have a Riverside Arms Co single shotgun do not know if 12 gauge or 16 gauge that belong to my Dad Found the number RP757 stamped on rifle behind the trigger Does this tell info about the rifle?
Sorry- that is a serial number, and conveys no information. If the barrel is not marked, you need to take it to a gunsmith who will measure the chamber- not only for gauge, but for the correct shell length. Just because an unfired shell fits does not mean it is the correct shell. And it is not a rifle, but a shotgun.
What barrel do I use for rifled slugs?
a slug is normally use in a shot gun and they are not rifled a gun with a rifled barrel should shoot a Shell that is the same caliber as the gun.
Origin and approx value of a external double hammer double trigger side by side shotgun marked London fine twist on the barrel 10 gauge as a 12 gauge shell is too small.?
England, impossible to give value without name of maker.
Where is the measurements made on barrel of sawed off shotgun?
Close the shotgun action and insert a rod down the barrel to the standing breech (to the rear edge of the chamber or where the back of the shotgun shell would be). Mark the end of the rod protruding from the barrel. Remove the rod and measure its length. Per federal law (GCA 1934), this must be a minimum of 18"
If a 20 gauge shell is placed in a 12 gauge shotgun what is the danger?
The danger is that the shell will fall forward, blocking the barrel, but allowing a 12 gauge shell to be loaded. If that is fired while the barrel is locked, the gun will likely blow up, destroying gun and injuring the shooter and innocent bystanders.
Is the barrel on the Winchester 1300 wtf interchangeable to a longer barrel?
Yes as long as you get one made for the Winchester model 1300 and chambered for the same length of shotgun shell that the receiver is chambered for.
Springfield 410 shotgun double. Looking for shell size?
Should use either 2 1/2" or 3" .410 shotgun shells.
