36mm
A 11/16 socket is needed to remove the 1984 Chevrolet pickup front axle hub assembly. The socket should be a five-point socket.
rear wheel drive or 4x4 capable
I have a leak on my drive shaft left front 2000 cheve Blazer I would like to replace the whole unit
i have a 1989 chevy blazer gos in 4x4 drive but front wheels are not pulling wat do i do about that
It is rear wheel drive, until you shift it into 4 wheel drive.
I jack up and support the front end, remove the front tires, and using a long "wobble" extension, 3/8" drive with the proper spark plug socket, go thru the wheel well opening.
You will need a 35 mm socket.
I use a 3/8" drive, 13mm swivel socket with a long extension and come in from the front just under the motor mount on the drivers side.
you dont, if you want to disconnect it then remove your front drive shaft.
YES, thats normal.
tAKE THE FRONT DRIVE SHAFT LOOSE AND SEE IF IT STILL DOES IT IF IT DOES ITS THE FRONT CARRIER ASSEMBLY IF IT DONT ITS THE TRANSFERCASE
2 wheel drive, yes. 4 wheel drive, no.