Want this question answered?
The T60 is the size needed to remove caliper bracket.
go to auto parts store and get the right filter for the Saturn then go to the filter wrench selection and find one that fits that is the style you like
1-3/8 Combo wrench or socket
You will need a 1" wrench to remove the one inside the Carb.
use a 1 and 1/4 inch socket to remove oil filter cap.
13mm for motor oil on E320
18mm
an ordinary crescent wrench will work just fine
its not a hex,,,it`s a torx t30 i believe
24 MM OIL FILTER AND t40 torx FOR PLUG
The filter is located almost directly underneath the fuel door on the driver's side. Spray some WD-40 on the coupler that fits the fuel line and filter. Let sit for about 10 minutes. You need 2 wrenches to remove the filter on the coupled side or you WILL snap the line. The other side is just a latch. You just pinch in the little buttons and it should come right off. If the wrench on the actual fuel line seems to slip, use a crescent wrench or adjustable wrench. Same thing. I believe the wrench size for the fuel filter itself is 5/8 butI don't recall. Fit a wrench to size with the new filter before removing the old one. Reverse the procedure to install. Oh you will get a little fuel coming out when you remove the old filter. Put a pan or old bowl down to avoid getting fuel all over.
A 46mm oil filter wrench is used on a 2003 BMW 325i. The wrench allows the center nut on the filter housing to be turned and removed easily.