use a 1 and 1/4 inch socket to remove oil filter cap.
you need 1.25'' wrench to open because this thing is plastic you need extra care to open
In order to remove the oil filter from a 2007 Toyota RAV4 you need to use an oil filter wrench. This wrench is a specialty to Toyota.
Use water pump pliers, they fit almost all oil filters.
a wrench with a metal band that wraps around oil filter that ables you to turn aka an oil filter wrench
any oil filter wrench - it warps around the filter and you can adjust it - the wrench looks like a giant ring
You need a special wrench from your auto parts store.Slide the wrenchup into the fuel line on either side of the filter.You need to turn the wrench and push toward the filter on either side. The wrench pushes back mini clamps that grab the flange on each filter end.You do not need the wrench to replace the filter.
What wrench size is need for a 2007 Honda Civic oil plug?
No..maybe a oil filter wrench to remove it, but, install it by hand (HAND TIGHT)
No. 2008 highlander has a aluminum filter housing you need to remove with a special type of filter wrench. I was able to tap mine loose without a wrench but it could be at 24n-m tight which is difficult to loosen.
Just unscrew the filter. If you cannot remove it with your hands, it was put on too tight, which is common, as most people tighten them too much. You will need to use a good filter wrench. The type wrench you will need depends on how much room you have. Oil the gasket & Put the new filter back on and only tighten it 3/4 turn after the filter makes contact with the mounting surface. By doing this you will not need a filter wrench when removing the filter next time. 3/4 turn is plenty tight and any more is too much.Just unscrew the filter. If you cannot remove it with your hands, it was put on too tight, which is common, as most people tighten them too much. You will need to use a good filter wrench. The type wrench you will need depends on how much room you have. Oil the gasket & Put the new filter back on and only tighten it 3/4 turn after the filter makes contact with the mounting surface. By doing this you will not need a filter wrench when removing the filter next time. 3/4 turn is plenty tight and any more is too much.
my wife has a 2007 4cyl fusion and the oil filter is locates unde the engine. If you jack up the front end and lay under the car you will see the plastic shrouds covering the bottom of the engine.On these shrouds there is writen where todrain the oil and where the filter is. You need a 10mm wrench to get the shroud off to get to the filter.
go to auto parts store and get the right filter for the Saturn then go to the filter wrench selection and find one that fits that is the style you like