According to the Clymer service manual, the spark gap should be 0.7-0.8 mm, as with most of these bikes. Actually, the required plugs (NGK BP7ES or BPR7ES, depending on who do you trust - the difference is an incorporated series resistor in the "R" plug) seem to come factory-set to that gap, but it never hurts to check, I guess...
How do you replace a speedometer cable on a 1984 Yamaha virago xv1000
The tires on a 1984 Yamaha Virago XV1000 are 100/90-19 for the front tire. The rear tire should be 140/90-15.
On the left side of the handle bar where the clutch attaches to the handle bar
The spark plugs are located right under the exhaust manifolds of both sides of the engine. You should just follow the spark plugs wire from the distributer.
There are four spark plugs in this bike's engine as it has a four cylinder V.
Use for example NGK DPR8EIX-9 or NGK DPR8EA-9 spark plugs.
The recommended spark plug, for a 1984. Thunderbird 302, V8 engine, is a champion spark plug. The spark plugs can be purchased at most auto-parts stores.
NGK D8EA/DR8EA/DR8EIX or equivalents.
the spark plugs are screwed into the engine block and the top part of them is covered by a single wire, if you have a four cylinder engine, there will be four spark plugs, the wires will all go from the spark plug to a distributor cap and should pull straight off on each end, if you are replacing the spark plugs make sure not to change any of the wire locations
20-40W is what the owners manual calls for. I believe it's 3.4 quarts with oil filter 3.3 without.
The spark plug gap for a 1984 258 6 cylinder Jeep should be set at .033 inches. New spark plugs will be preset and should not need adjustments.
depending on the engine size they will be located in the sides of the heads. look for a rotor cap and 6 or 8 big wires, depending on the engine, then foller them rihgt down to the spark plugs.