Right hand thread
Not all crankshaft pulley bolts are left hand thread. In my experience if it is a left hand thread the bolt head normally has an L stamped on it to notify the direction of thread
1998 Nissan pathfinder crankshaft pulley bolt is right handed.
No. But it's tight.
crankshaft pulley bolt is left hand thread,so it will come out opposite direction to normal bolts
i am sure its left hand thread
More than likely it is right hand thread.
No. It is standard thread. (righty tighty, lefty loosey)
most crankshaft pulleys have a left hand thread. this means it turns opposite direction or clockwise to remove
no it is not left handed,some times just a real pain getting off.
It is right hand thread. Turn counter clockwise to loosen.
remove 22mm center bolt its regular thread there are 2 threaded holes in pulley you will need the right pulley remover with the right bolts for the pulley you can get this at most parts stores make sure to not mess up crankshaft bolt threads
My grandmother sews with a needle and thread. She lost the thread of the conversation. Help me thread the rope through the pulley. The girls was threading beads on a string.
Easy, remove tensioner pulley (13mm left handed thread). Replace pulley Remove 2nd pulley (13mm I think, normal thread) Remove 3rd pulley (13mm I think, normal thread, found below 2nd pulley) Look up VY pulley on google to get a diagram and parts numbers. its simply a matter of unscrewing the bolt and sliding a new pulley in. might as well do drive belt while your there. Costs around $100 all up and takes under an hour :D
The bolt is normal thread, righty tightly, lefty loosely.Using a cordless Impact gun is the easiest way to remove it without having to hold the pulley from turning. It should be a 15/16 or whichever size is equivalent in metric measurements.
Tensioner assembly removes with std. thread -- pulley itself is a left handed thread Clockwise to loosen
The answer is probably a pulley. That's probably the answer because tautness means tight or tightly and a pulley causes a thread or a rope to be pulled tightly or tautly.
Right hand thread
It is a standered fine thread bolt, Grade 8
facing the engine you turn to the right it is r/ hand thread if you look at tne bolt head which is behind the pulley
standard thread on the 99 model with 4.0 liter.
Contact your local auto parts store or a Mitsubishi dealer.
smallblock chevys usually use studs for water pump pulley. the thread size is 5/16" dia. nf (national fine thread) on the water pump flange side and 5/16" course thread on the pulley side of stud. if you use bolts you will need 5/16"NF x 3/4" long.