0
Use a "torx" head screwdriver.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
How do you remove the horseshoe shape pin to release window crank of 1997 Saturn?
You need a special tool to remove it . The tool slides between the door and the handle and pushes the clip out
1991 Saturn SC fuel pump?
Located in the fuel tank, and requires special tool to remove.
How do you remove sun visor on 2006 rav4?
You need to pull the plastic cover over the visor swing joint straight down. On each end of the oval cover there is a small groove to allow you to insert a tool with a 90 degree bend into to grab both ends at the same time. Once this piece is pulled down and removed the spring clips holding the visor on are unlocked. Just pull the visor out of the connector housing.
What size torque tool used to remove 2000 wrangler mirror?
12
What is tool size to remove block coolant drain plug 2000 Jeep 4.0?
8mm square. Now, where do we find the tool?
How do you remove the oil filter housing on a 2001 Saturn sl1?
twist it counter clockwise. A oil filter remval tool may be needed
How do you align rear wheels on a Saturn sl2?
rear wheel alighnment on a Saturn requires a special tool available at Saturn or through most large tool companies.
How do you remove the fan assembly from the water pump on 2000 ram 1500 5.2L?
use the special tool for that
Where is the fuel filter located on a 1993 Saturn?
It's an Inline metal filter under the car and you need a special snap arround tool to remove it.
How do you change a fuel filter on a 2001 Saturn SC2?
You do NOT need a special tool to remove the filter http://www.youtube.com/watch?v=0FqLKzINM6s -RC-
How do you remove the front drivers side door panel on a 2001 Saturn L200?
remove the door and window crank handles with a special tool from the parts store, Then all of the screws you can find esp at the corners. Then the retainers with a special tool around the sides and botton fo the door.This is not an easy job.
Is it possible to remove the transmission on a 1995 Saturn SC2 from the bottom without having to remove the engine?
no not at all not enough room.if it's standered and you need to replace the clutch you have just enough room to remove and install the clutch remember cut the clutch tool in half
