Brake Pads and Rotors
Ford Focus
Thermostats

What tools are needed to replace the drive belt on a 2000 ford focus?

171819

Top Answer
User Avatar
Wiki User
2006-04-15 22:30:20
2006-04-15 22:30:20

Only a wrench to rotate the belt tensioner to releive the belt tension. You have to get at it via the passenger-side front wheel well. The longer the length of the wrench, the better.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Tools needed to replace front brakes 2002 Ford Focus?

User Avatar

What tools are needed to replace secondary air pump on 2001 Oldsmobile intrique

User Avatar

Do I need any special tools to replace front wheel bearings on a Saturn 2002 L200?Also what is the procedure for doing so?

User Avatar

You can replace the drive on your PlayStation, but only if you are comofortable with disassembling electronics.

User Avatar

all you need to change the thermostat is a #25 trox driver- there are three screws 2 at the top and 1 on the lower left side

User Avatar

Common hand tools, sockets and wrenches. Nothing special.

User Avatar

Plumbing tools should be replaced as needed,most quality tools carry a lifetime warranty.

User Avatar

To replace the brake pads on a Toyota Tercel a jack is needed. Some other tools that will be used are a socket wrench, screwdriver, lug wrench, and a pair of pliers.

User Avatar

There are a few basic tools needed for computer programming. A developer will want to have a word processing application, a development application, and a flash drive.

User Avatar

To replace the brake pads on a 96 Grand Am, three tools will be needed. First, a C-Clamp, then a hex key to remove the caliper bolts, and a screwdriver to work the caliper free.

User Avatar

The tools needed for an oil change tend to be common tools. A floor jack is needed to access the oil pan. A pan which is used to drain oil into. A wrench and socket set is used to remove and replace the oil cap.

User Avatar

Make darn sure it isn't the tire first. Take the strut off, and have the bearing pressed.

User Avatar

All you need is common hand tools. A boxed end wrench and sockets.

User Avatar

The oil pan must be removed. No special tools required, just normal mechanics tools.

User Avatar

becase if they have specal tools that are needed to replace the string.

User Avatar

the only tools need are a 17 inch socket a rachet a "C" clamp to push the piston back in.

User Avatar

It is pretty technical and special tools are needed. Take it to a garage.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.