Use only genuine Honda ATF DW-1 Transmission Fluid in the A/T and nothing else. Do not use any other fluid that claims to be compatible.
transmission down shift after fuild change
when to change transmission fuild in 2005 highlander
Yes. If you do not want a big mess, I would suggest draining the tranny fuild before pulling out the half-shafts (axles)
Dextron III
mercon v
The automatic transmission uses ATF+4.
Read you owners manual.. that's what its there for.
It requires a special tool that only the dealer has.
With the egine and transmission at normal operating temp and the car level you remove the small pipe plug located at the output same of the right front axel shaft. A small amount of fuild should run out. If it doesn't you add fuild until it does, then reinstall the plug. Be careful because the fuild is HOT!
It requires a scan tool and a special tool that only the dealer and transmission shops will have.
Simply pull the handle out of the trans fuild filler port in the engine compartment and fill until the dipstick reads full. courtesy of www.TheProwlerStore.com
Refer to your owners manual. Don't think this requires additional trans fuild. The transmission is designed that way.