0
rubber hose
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
How would you replace the Fuel Pump for a 94 Passport?
You have to drop the fuel tank off the frame of the car. There is a pan you have to remove first, then the fuel filler and vent hose and finally a few wires have to be disconnected and the tank comes down. You can use a jack to support the tank. The fuel pump then comes out of the top of the tank.
How do you replace the Rubber Fuel line hose on a 1993 Buick Regal Gran Sport?
You have to drop fuel tank and use quick disconnect tool to change lines
How do you install a fuel pump in a 92 Chevy blazer?
Drain the fuel tank, remove the fuel fill hose from the side of the truck. Remove retaining straps for the fuel tank, lower slightly. Remove fuel hoses from fuel tank, noting which line goes to which hose. Remove fuel gauge wire. Drop fuel tank out of the truck. Blow off excessive dirt from the top of the fuel tank, use a special tool to rotate the retaining ring around the fuel line inlet into the tank. After you remove the ring, lift out fuel sender/pump assembly, noting which direction the assembly was in, as well as which direction the fuel sock is pointed at the bottom of the fuel pump. Replace pump & fuel sock. Reassemble.
How can you replace a leaking fule line or can you splice it?
if the fuel line is steel then cut out the bad spot, and go to auto parts store and buy fuel injector hose. put hose where line is cut out and use fuel injector type clamps to hold hose.
Can you siphon fuel from a 2003 GM 2500 4 Wheel Drive Sierra?
Sure you can. Just use a hose and siphon it out of the gas tank.
How do you remove and install a gas tank on a 91 s10 Blazer?
See if this helps. 1. Remove fuel from your gas tank. 2. Take off clamp to filler hose and disconnect filler hose and vent line. 3. Remove fuel tank retaining straps and support tank with a jack. 4. Lower fuel tank with jack to disconnect sending unit wires, hoses, and ground strap. 5. Carefully remove fuel tank from vehicle. 6. Take out fuel pump. Use brass punch and hammer for retaining ring. Reverse the above procedure for installation.
How do you get diesel out of petrol car?
Use a siphon hose inserted into the tank. To get the remaining fuel out or if your vehicle has an anti siphon device you will have to disconnect a fuel line and turn on the key. This will activate the fuel pump and fuel will flow from the line.
How do you remove rear fuel tank on a 1997 Ford F-350 diesel to remove water from tank?
to remove the tank, first thing u need to do is try to use as much fuel from tank as possible remove spare wheel then if you have a floor jack ,u need to support the tank there are 2 straps that support the tank u need to remove bolts that hold these straps disconnect fuel filler hose from tank disconnect fuel supply line from tank disconect fuel gauge wire lower fuel tank on jack ps there are fuel additives you can buy that will remove water from the fuel and tank also a nother way to do this is add about 1/2 gallon of gasoline to full tank of fuel the gasoline will burn off water when it burns in fuel with normal use
What is the best way to clean a plastic hose for a fish tank?
The best way to clean a plastic hose for a fish tank is to use pipe cleaners, depending on the width of the interior tube you may be able to use a rag as a pipe cleaner type tool and just spin the rag through the hose until it is clean.
How do you drain fuel tank on cub cadet?
Without removing the tank, the easiest way is to remove the fuel line from the tank, connect a 2 foot piece of line to the tank, open the petcock and drain into a bucket or gas can. To remove any left over fuel in hard to reach places, use an old turkey baster.
Can you siphon fuel from a 2003 Ford Ranger?
if you use a very small hose you can like the type used in fish tanks
Can you siphon gas from a 1998 Dodge Durango?
Without disassembling the tank, filler neck, etc. no you can't. If you need to drain fuel the easiest way is using a fuel pressure gauge attached to the fuel rail - use the bleed off and run the pump, that is, assuming the pump works. If that is not an option disconnect the fuel filler hose from the tank and look at the neck of the tank itself - there was a removable insert on some of these that inhibits fuel syphoning. If you pull it out the hole is open and fuel can be pulled out. If the insert is permanently fixed your only other option is to drop the tank far enough to remove the fuel sender retaining ring, lift the sender out a few inches, and insert a hose directly into the tank.
