Try Napa, or just go to a Mazda dealers part dept. They come in both spin on and cartride. And if i remember correctly it is 4.5 qts.AnswerIt is a cartridge. Make sure you get the kit, because you will need the O-rings, also. FYI, you need to get a "special" wrench to remove the housing in order to replace the oil filter. These parts can all be purchased at a Mazda dealer's parts department or online. AnswerI love my 2005 Mazda 3 2.3 liter, but we can't find oil filters ANYWHERE!!! The guy at Autozone said they didn't even have access to order one. Normally not a big deal, but my husband has never and will never take a vehicle to someone else to change the oil. AnswerAutozone does carry oil filters for Mazda 3's. You can find them here:
yes, it has an oil filter.
The Mazda 2.0 liter engine oil filter can be found on the left-hand side of the engine. The oil filter will be near the oil pan.
It is above the oil pan.
3.4 quarts without oil filter replacement. 3.8-4.0 quarts with oil filter replacement.
5 quarts / 4.7 liters , with engine oil filter change
The 3.7 liter is 3.9 quarts with oil/fiilter change. The 4.9 liter is 5.2 quarts with oil/filter change.
The oil capacity for a 2000 Mazda Protege with a 1.6 Litre engine is 2.9 litres with an oil filter change ........... it is 2.7 without an oil filter change but who in their right mind would change an engine's oil without changing the filter is beyond me ??!!
The set include an electric filter. It has carbon cartridge, sponge, and spare part of these. The capacity of filtered water can adjust on the top of the filter. The maximum capacity 200 liter/hour. It is more than enough in a 5,5liters tank.
2004 + 5.5 U.S. quarts in the engine. 0.5 quarts in the filter. Total 6 U.S. Quarts.
( 5 quarts ) with engine oil filter change for the 4.0 liter V6 and 5.0 liter V8
According to Mazda, both the 2.0-liter and 2.3-liter engines have a maximum speed of 117.5 mph.
yeah it is
According to the 2011 Ford Escape Owner Guide : For the 3.0 liter V6 engine ( Motorcraft FL-500-S engine oil filter ) For the 2.5 liter four cylinder engine (Motorcraft FL-910 engine oil filter * ) ( * I was looking at www.fordparts.com and it shows part # FL-910 as being a spin on type of oil filter , apparently there is also a cartridge type oil filter , but Ford doesn't show the part # for that )
The millenia P - has 2.5 liter engine, The Millenia S has a 2.3 liter engine
If you are changing the oil and the filter then you will need 5 quarts.
The 2.2 liter 4 cylinder and the 3.0 liter V6.
Yes, there is a 1.6 Mazda
Your 1998 Mazda 3.1 liter engine does not have timing marks on the crankshaft. The timing marks are on the engine flywheel.
The Mazda 3 oil filter is on the right side of the engine between the right front wheel and the engine. It is best to remove the plastic underpan bolts, to change it. You do not have to remove the center bolt to drain it first. Remove the housing, lefty loosy, with a plier type wrench or one that fits the bottom serrations and then replace the cartridge insert and the o ring gasket.
NO it is not. But you do need to change the oil and filter.
For the 2004 Ford Freestar : 3.9 and 4.2 liter V6 engines : ( Motorcraft FL-400-S engine oil filter ) according to one of Fords websites
The owner's manual of my early 2008 Mazda 3 s 2.3 liter says that it holds 4.5 U.S. Quarts of oil.
The amount of oil that goes into a Mazda 3 2.3 liter engine is 4.5 quarts. This would equal 4.3 liters.
The 5.4 liter takes the ( Motorcraft FL-820-S ) engine oil filter