0
What valve compressor tool to use for a Geo Metro G10 engine 3 cyl SOHC and where to purchase it?
Wiki User
∙ 17y ago
Make a folcrum or use a "C" clamp: take a 1" piece of copper pipe 4" long, cut 2 slots (1/2" wide 180 degrees from each other)on one end.
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
Where is the PCV valve on a 1999 basic Chevy Metro 1.0?
The 1999 Chevy Geo Metro 1.0 liter engine PCV valve can be found on top of the engine. The PCV valve will be behind the air cleaner housing.
Where is the pcv valve located on a 1998 Chevy Metro with a 1.3 liter 4 cylinder engine?
center of valve cover at rear of motor
Where can you get a Chrysler tool C4682 for valve spring depress on turbo III 2.2 engine?
KD Tools Valve Spring Compressor 3087
Engine knocks is it map sensor or knock senor?
It may be map sensor but engine knocking cause of another reason. You should check your spark plug , I.S.C valve , Injector and engine Compressor. thanks It may be map sensor but engine knocking cause of another reason. You should check your spark plug , I.S.C valve , Injector and engine Compressor. thanks
Where is the ac recharge valve for a 2003 ford focus with a zetec engine?
The AC recharge valve for a 2003 Ford Focus with a Zetec engine is near the firewall. It is the larger of the two lines going to the compressor.
How to compress valve springs?
If the head is still on the engine, you can purchase a kit at most auto parts stores that includes: an air fitting to keep the cylinder filled with compressed air to prevent the valve from dropping into the cylinder, and a special wrench to attach to the rocker stud and press down on the spring retainer while you remove the locks. If the head is off the engine, you will need a valve spring compressor, which is a large c-shaped tool that pushes on the valve's head on one end and the valve spring retainer on the other end. Also you can buy/rent a valve spring compressor that you can use while the head is still on the engine but you will still need to blow air into the cylinder through the spark plug hole to keep the valve up.
Where is the ac low-pressure valve located in the engine compartment of a 1996 Isuzu Rodeo?
The AC low pressure valve on a 1996 Isuzu Rodeo is located in the back of the engine compartment. The valve is on the larger of the two hoses that run from the evaporator to the compressor.
What is the head bolt torque specifications and sequence for a 1995 geo metro 3 cylinder engine?
valve seal possition
Where is the EGR valve on a 1991 Geo Metro?
The 1991 Geo Metro EGR valve can be located on the air cleaner housing. The valve will be on the back of the housing.
where can i get a pilot valve?
where can i get a pilot valve for gas air compressor
What is the name of valve using in reciprocating compressor?
damber valve
What is the function of a bypass valve?
To prevent compressor surge, and reduce wear on the turbocharger and engine. Or in other words to prevent issues such as clogging from occurring on to reduce the issues on the turbocharger and engine.
