0
What will cause a fuel pump to keep going out on a 1995 villager mercury have been replaced 4 times in the past two years?
Wiki User
∙ 14y ago
You have poor or defective wiring/voltage, dirt or water in the tank, or you are using poor quality replacement parts. These fuel pumps are not prone to trouble.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
What would cause your 1996 mercury villager transmission to slip when going into 3rd gear?
This indicates severe wear and impending failure, it will probably need to be rebuilt or replaced.
What can cause the Check engine light on a 2001 mercury villager to stay on?
There are many, many things that can cause the MIL to light up. You will need to have the problem diagnosed by first reading the codes and going from there.
What would cause vehicle to surge while the AC is on 1998 Mercury Villager?
my guess would be a catalytic converter going bad. you can remove the front oxygen sensor and drive it. if the problem goes away then it is probably the catalytic converter. nth njth ///////???????????????????kldghavnivaetahdsngahe
What is the best replacement battery for a Mercury Villager van?
I prefer to use Duracell batteries . . . they keep going, and going, and going . . . = = Answer = = Any good national brand battery with at least 850 CCA (cold cranking amps) Then have your charging system checked.
Is there going to be virtual villager 4?
yes
Does a 93 mercury villager have a fuel pump emergency switch?
A 1997 Villager has a red button behind the driver side kick panel next to parking brake pedal. I found it by going to Ford.com/parts down loaded the owners manual. If you don't have the owners manual thy this.
Where is the number one cillynder on a93 villager?
On a 1993 Mercury Villager , 3.0L V6 engine : Standing in front of the vehicle looking into the engine compartment : The back three engine cylinders , by the firewall are numbered : 1 - 3 - 5 ( going from your left to right ) And the front three engine cylinders are numbered : 2 - 4 - 6 ( going from your left to right )
What Nissan part number would you need to replace the rear exhaust manifold on a 2000 mercury villager 3.3 engine?
Nissan isn't going to stock any parts for this, try Rockauto.com or eBay.
Why does the van jerk when going into second gear on a 1997 mercury villager?
There are a number of possibilities. Some of these vehicles had a problem with a loose ground wire on one of the shift solenoids. This is addressed in a dealer TSB. There can be other issues such as internal wear on servos or spool valves that can cause this behavior. If this is the case a rebuild or new transmission is indicated.
How much for to repair a head gasket for a 2000 Mercury Villager?
Last I heard, the going price at a dealership was $1500 or more depending on what else might be found. For example; water pump, timing belt, rod bearings.
Why would the automatic seat belt on a 1995 Mercury Villager not move the sealt belt but the motor keeps going and will not shut off?
There is a flat belt that moves the seatbelt holder. This belt has indentations on it that mate with a gear that is driven by the motor. Those indentations tend to wear out and cause the belt to not move or get stuck in the motor gearbox. The motor and gearbox are located at the lower end of the center collumn. If the belt is not moving through the gearbox it does not send the seatbelt holder all the way to the front of the car where a switch is located. If the switch is not activated the motor will not shut off. You need to replace the belt. I replaced the belt on my 93 villager and it is dam expensive about 50 to 80 dollars as I remember. I was mad about that but it was not available at an auto parts dealer and the mercury dealer was my only choice. Good luck. I replaced twice the plastic pinion located on the electric motor. In both instances, the flat belt was good.
Why does the alternator keep going bad in 1994 Mercury Topaz?
i have an 87 topaz where the alternator goes bad also. have replaced it twice. it is just a common problem in the topaz's
