answersLogoWhite

0


Best Answer

2 trannys with same problem?

computer controlled , yes , no power is third gear. is car in neutral or just slipping in 3rd?

If in third, suspect wiring problem

If is in neutral could be fluid or mechanical problem

Warm it up, try a launch test to see if it slips when warm

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What would cause a tranny on a 94 LeSabre to be stuck in neutral at cold start drives and shifts normally after warm up tranny replaced with the same result?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What could be wrong if a 1996 Buick LeSabre starts and drives then will not start again?

I had the same problem with a 1992 Park Avenue with the 3800 engine. I first replaced the electronic ignition but that did not fix the problem. I then replaced the crankshaft heat sensor. That fixed my problem.


What are the weaknesses of hard drives?

Like anything mechanical, hard drives will eventual wear out and need to be replaced.


Are all laptops equipped with 2.5 hard drives?

Mac laptops may likely have solid state drives (not hard drives). Those drives are 2.5" form factor and can be replaced by hard drives.


How a 1998 trans am wont reverse but drives in neutral?

Hoe a train moves.


What drives the oil pump in an automobile?

Normally the crankshaft but not always.


What replaced the floppy disc?

Includes:CD and DVD burnersUSB flash drives


Why does your ford windstar only drive in neutral?

If a Ford Windstar only drives in neutral, it may be due to a blown fuse. It will be best to check the neutral safety switch or brake pedal switch.


Where is the starter on the 1995 Buick leSabre?

Starter is located on the side closest to the radiator, and closest to the transmittion. Transmittion is on the drives side of the car, and radiator is on the front


How a 1996 Avalon wont reverse but drives in neutral?

Shift linkage may need to be adjusted?


What might be the purpose for SATA style power connector?

a sata power connector is normally used for powering sata dvd drives as well as sata hard drives and ssd drives


Why do you still need floppy drives?

normally for backup purpouses and boot disks


What types of computer memory bases on computer?

normally RAM and H drives are on most computers. other just use there flash drives or floppy disks