It is telling you that one of the gauges is not within normal range. It could be you are not charging or overheating or have little or no oil pressure.
I i have the same problem, please let me know iff someone answers, email@example.com
The check gauges light stays on when one of the gauges is out of the safe or normal range.
1999 Chevy table oil pressure gauge low and check gauges flickering
Take it into the shop
Look for a blown fuse.
it looks like palo alto speedmeter
There are many things that could be causing a loss of power. Some of the main things would be damaged wiring, drained battery, bad starter, bad alternator and bad solenoid.
My older Blazer has a 'check engine' light and also a 'check gauges' light. When the 'check gauges' light is on, check your other gauges like the temp and volt gauges. One of them may be showing something different than normal.
A bad power steering pump, You need to either check the fluid level and make sure there is enough or have it replaced.
a disconnected wire or a bad resister in the electrical system it happened to mine
No coolant in the system, failed thermostat, failed water pump, leaky headgasket.
The instrument cluster can cause that problem. It shorts out the communication system between the computers.
I didn't find any sensors or switches related to the power steering, so I'd think the pump was bad.
You either have Faulty outlets, in which case you would need to replace and refuse, or your fuses are burnt, and need to be replaced.
troubleshoot the coolant on a 1999 oldsmobile intruge
Yes, as the mixture would run lean and possible misfires could occur.
Yes... the "Check Gauges" light will light.
recomend to take to good shop indepindent or dealer to have checked out too many different things could cause this need to have truck and scann tool to tell.
the horse power would be 564hp
When one of your gauges shows something abnormal, your "check gauges" light will come one. Chances are you're low on motor oil. When you corner, the oil will slosh away from the pickup, causing your oil pressure gauge to read zero for a second. This in turn causes your check gauges light to come on, but by the time you look at your gauges, the oil has settled in the pan is your oil pressure is reading normal again. When you see the check gauges light and the gauges are reading fine, check your oil.
Not sure about yours but I I know that sometimes we leave our window down and rain may get into the controls on the inside of the door and cause them to corrode and not make good connection under them.Good luck.
One thing that would cause your 1999 Pontiac Montana to stall at idle is the idle being set too low. You should raise it to see if that fixes the problem.
Trucks - 1999 Project Rolling Thunder Part 15 Gauges and Dent Repair 2012-3 was released on: USA: May 2012