Spark Plugs and Wires
Toyota Camry
Ford Explorer Sport
Ford Explorer XLT

What would cause oil to leak into the spark plug tubes on a Toyota Cressida with a 6.0 cyl 3.0 engine and what do I need to do to fix it?

171819

Top Answer
User Avatar
Wiki User
2005-10-29 19:57:48
2005-10-29 19:57:48

the tubes leak past the threads where they screw into the cylinder head. remove the valve covor and take one of the nuts that hold it down and install it on the affected tube upside down. take another one of the nuts and install it rightside up. lock the 2 together by tightening them against each other. use a 1-1/4" wrench on the bottom nut to turn the tube out. clean the threads well and apply red loctite and reinstall using the top nut. this should solve the problem.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

how the sequence of spark plugs goes on the engine of 1990 Toyota cressida

User Avatar

Disconnect a sparkplug wire or 2 and ground it to the engine and crank engine over-you should get a snapping blue spark

User Avatar

Toyota spark plugs from dealer pre gaped

User Avatar

I think it's "40". Any other suggestions????

User Avatar

spark plug gap for Toyota 2.7 enines is .032.

User Avatar

The 2000 Toyota Avalon spark plugs can be located on each side of the engine. The spark plugs will be near the bottom of the engine. There are three spark plugs on each side.

User Avatar

The recommended spark plug gap for a 1994 Toyota 22RE is .032"

User Avatar

There could be a humming noise from the engine of a 2002 Toyota Corolla because of low oil or a fouled spark plug. It can also indicate a more serious problem.

User Avatar

Yes, it can cause check engine light to come on. Reasons are multiple - anything from air/vacuum leak, spark problems etc. to major failure.

User Avatar

1990 tacoma 2.4L engine what should the spark plug gap be?

User Avatar

You need to check the fuse box in the engine compartment it's full of relays ans fuses responsible for gas and spark delivery.

User Avatar

follow the spark plug wire to the engine head and there they are

User Avatar

If your engine is a V6 you will have 6 spark plug wires , the engine is V shaped , there will be 3 spark plug wires going to the front and 3 going to the back of the engine : X-----X-----X X-----X-----X front of Toyota Camry If your engine is a 4 cylinder , you will have 4 spark plug wires , the engine will be : X----X----X----X front of Toyota Camry

User Avatar

The engine needs fuel, compression and spark. You are missing one of those.

User Avatar

you have to make sure that your engine is set at tdc (top dead center) then you have to put the rotor set at the number one spark plug wire,make sure you put the distributer in carefully and not to damage the shaft.

User Avatar

Each engine in a Toyota uses a different Spark plug depending on size and model. The owners manual will tell you the correct size for your engine.

User Avatar

When changing spark plugs it is important to know their location under the hood of the car. For a Toyota Rav4 the spark plugs are under the engine cover that has the car symbol on it.

User Avatar

Corollas has a four cylinder engine, it means it has 4 spark plugs.

User Avatar

In the cylinder head, on top of the engine block.

User Avatar

Below the Ignition coils on top of the engine.

User Avatar

four, as it is a four cylinder engine with one spark plug per cylinder.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.