0
problem in the clutch linkage or throwout bearing, check for binding in the exterior linkage before getting into the bearing, it may be worn or just binding on the shaft, could also be clutch itself as springs may be weak from time
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
On a 1990 Isuzu Amigo what would cause the clutch pedal to stick to the floor?
if its hydraulic there could be air in your line. bleed your clutch and refill.
What would cause stick shift to jam when car is on and clutch pressed but shift fine when car is off without stepping on clutch?
sounds like clutch needs adjustment or time to replace it
What would cause a whining sound when you press in your clutch?
A worn out clutch release bearing would cause a whining sound when you put your foot on the clutch.
What would cause a stick shift to slip out of first and third gears when the clutch is engaged?
It's worn out, bad linkage or worn shift levers.
What makes car stall while in gear?
A problem in the fuel line could cause it to stall. On a stick shift, letting off the clutch too soon would cause the vehicle to stall.
How do you repair a clutch valve in an Olds Cutlass and also what would cause RPM's to increase as speed decreases?
Your car if its a stick is not pulling out of gear all the way and your moter overrevs
What would cause your rm125 dirt bikes clutch not engage?
bad clutch cable, or not enough oil on the clutch plates.
What would cause my car to loose all gears after having the clutch adjusted?
Clutch is not adjusted properly.
Will low hydraulic oil in trans for a Chevy s-10 2.2 cause clutch not to engage?
There is no hydraulic fluid in the transmission. However, there is hydraulic fluid in the clutch system. If the clutch fluid reservoir is empty it would cause clutch not to operate.
Why would the gear shift stick?
Possible bad clutch will do it. Check to make sure that the trans fluid is full with the right viscosity and check the clutch, clutch master cylinder,& the slave clyinder in the transmission.
What would cause a slight nosie near clutch area and goes away when you pull on the clutch lever kx125 kawasaki?
Slack in the clutch release or clutch basket. It might adjust out.
What would cause gears to grind?
your clutch may not be fully engaging
