kerosene has got higher ignition temperature.
you need a new ignition tumbler.
Check to see if you are getting spark (coil) and fuel
The 1999 Jeep Cherokee ignition coil used a black wire for the negative wire. The negative wire should be on the left post.
wood,leaves,paper
THANKS BUT I FOUND ANSWER.................The Engine Immobilizer Indicator Light is supposed to flash continually when your key is removed from the ignition
I have a 2004 Odyssey. Here's what the manual has to say about the green key indicator on the instrument panel: "Immobilizer System Indicator. This indicator comes on when you turn the ignition switch to ON. It will then go off if you have inserted a properly-coded ignition key. If it is not a properly-coded key, the indicator will blink and the engine will not start. This indicator also blinks several times when you turn the ignition switch from ON to ACCESSORY or LOCK." Hope this helps!
immobilizer is in the key and pickup ring on the ignition lock
The Engine Immobilizer Indicator Light is supposed to flash continually when your key is removed from the ignition because it is part of the security/alarm system. The engine immobilizer is the " kill switch " that will not allow the engine to be started without your key which has a microchip in the top ( the black part of the key ). When the EII Light is flashing it indicates that that part of the alarm system is active and working. If the light does not blink when key is removed THEN it needs to be fixed.
Take to auto electricians as I had the same problem and they found a conlog relay for ignition faulty. after it was replaced car was working fine.
You can reset the immobilizer on a Citroen C4 in one easy step. Simply insert the key into the ignition and turn it very slowly.
the engine wont start unless you have the immobalizer key
put the key in the ignition turn the key to the second setting on the ignition lock (marked | )while in this position press the key to lock/unlock the car this resets the immobilizer and the central locking
u cant the immobilizer is built into the engine mine went i had to keep inserting the key in and out of the ignition
have lost code for my pug and i dont know how2 disarm it can u help Think you have to remove drivers seat to get at wiring Think you should sell the car on Ebay, and attach a rear spoiler To unlock the immobilizer there is a button with lines on it near the ignition switch, as you turn the ignition press this button, it will turn off the immobilizer.
There are several possible solutions to reset the immobilizer, assuming you can get into the car, the reset can be done by putting the key into the ignition and leaving the key there without starting the car.
You have an immobilizer problem. Try another key.