answersLogoWhite

0

  • Transmissions and Drivetrains
  • Transmission Fluid
  • Chevy Blazer S-10

What would cause transmission fluid to leak from the driveshaft yoke on a 95 Chevy Blazer 4wd 4.3 vortec vin code w?

User Avatar

Wiki User

βˆ™ 2006-09-06 17:34:55

Best Answer
Copy

Bad Rear Transmission Seal. When You Pull The Drive Shaft To Install A New One, Check Your U Joints. While You Have It Out May Need To Replace One. Also Check To See If The Yoke Has A Lot Of Wear Where The Seal Is Located, They Used To Make An Undersize Seal & Sleeve To Take Care Of This If It Is Realy Bad. Don`t Know If They Do Now. GOOD LUCK

2006-09-06 17:34:55
This answer is:
πŸ€“
🀯
πŸ€”
User Avatar

Your Answer

Loading...

Related Questions

Where is the location of transfer case on 1998 Chevy blazer?

It is bolted to the back of the transmission and then the driveshaft on the rear slides into it.


Will a 2002 Chevy blazer transmission4l60e fit a 1995 gmc jimmy 4.3 v6 vortec?

No it will not. The design of the 2002 Transmission is different.


How do you set timing on a 2000 Chevy blazer s10 v6 vortec?

On the Vortec the computer does it all.


How much is a transmission flush?

how much should it cost for tranny flush on 1995 s-10 Chevy blazer 4x4 4.3lt vortec


Can a 94 Chevy 4.3 vortec fit a 96 Chevy blazer?

no the heads are diffrent


Could a stock 2002 Chevy blazer vortec 4.3 tow 2000 pounds?

I would like to know if my 2002 chevy blazer with a stock 4.3 vortec pull 2000 lbs ?


Will a transmission from a 85 Chevy K5 blazer 4x4 fit an 87 Chevy k5 blazer 4x4?

can I put a 99 Chevy 4l60e transmission in my 86 k5 chevy blazer


What vehicles had a 350 ci vortec motor?

Chevy blazer '78


Will the transmission from a 2005 Chevy blazer work in a 1998 Chevy blazer?

Yes, they both had the same transmission options.


Where to find transmission fluid dipstick on 96 Chevy blazer?

where can i buy a transmission dip stick for a 1995 chevy blazer


What is the long round thing underneath your Chevy blazer in the middle?

Could be the driveshaft.


Will a 2003 s10 Chevy Blazer transmission fit a 2002 Chevy Blazer?

Yes


Will a 2000 Chevy s10 blazer 4x4 transmission work for a 1998 Chevy s10 blazer?

Will a 2000 blazer transmission fit a 1998 s 10 chevy 4x4 truck


You have 1999 Chevy Blazer S-10 4.3 Vortec engine what type of transmission do you have or number How would you know and where can you find out where?

Most likely it has a 4L60E


Need to know transmission for a 1994 Chevy S-10 blazer 4x4 v-6 automatic vortec engine with a vin number of 1gndt13w1r0152579?

That would be the 4L60E transmission.


Is it possible to tighten Flywheel on a 2001 Chevy Blazer without removing the housing or starter?

NO. You will have to remove the transmission bolts and move the transmission back alittle after you have removed the driveshaft,transmission lines,crossmember bolts,starter,flywheel dust cover,front driveshaft,torque converter bolts. NO OTHER WAY.


How many quarts of oil does a 95 Chevy blazer hold?

My Blazer 4.3L vortec holds about 4.5 - 5 quarts


Where is the fuel pump on a Chevy 1994 blazer vortec v 6?

Inside the tank.


Where is the fuel pressure regulator on a 1995 Chevy blazer 4.3L vortec?

It is in the throttle body.


What manual transmission fits to a Chevy 4.3 vortec?

nv3500


Will a 1995 Chevy Blazer lt transmission fit a 2000 Chevy Blazer lt?

No it will not work, Is it not the same.


Will a 2000 Chevy Blazer transmission fit into a 1998 Chevy Blazer?

NO it will not. They are complete DIFFERENT designs. Will NOT interchange.


How do you replace a fan belt on a Chevy blazer 4 x 4 need diagram?

how to change the fan belt on a 1995 Chevy blazer vortec motor?


Location ground strap 1997 Chevy blazer 4.3 Vortec?

The ground strap on a 1997 Chevy Blazer 4.3 Vortec is located along the bottom of the engine near the frame. It ensures that electricity flows properly through the entire vehicle.


How do you remove a you-joint on a 1996 Chevy s10 blazer?

or you talking about the driveshaft u-joint?