what can cause a 2002 buick lesabre to not crank
what would cause a 1994 Buick LeSabre v6 to turn off going down the road.
fan or thermostat not working
Bad wheel bearing.
the tps is bad-throttle positioning sensor
only thing that will cause smoke in steering column,is an electrical short in the wiring inside the steering column
Check the belts. The most common cause of squealing is a worn or loose belt on the front of the engine.
wheel bearings are going bad, need to change your hub assembly
NO the transmission fluid will cause the seals in the pump to leak
have u checked spark plug wires, ignition coils, timing,spark plugs or had it hooked to a reader?
94 Buick LeSabre, runs great until I step on gas and then it starts to chug and hesitate
Bad wheel alignment, perhaps balljoints worn out.
The transmission is usually pretty vibration free. Check the CV joints. Hopefully it is not the flywheel.
I have a 95, had a misfire... mine was because of the plug wires... changed the wires and plugs mis fire stopped...
The same place the transmission fluid dipstick is. Be sure that you actually need to add fluid or you can cause serious damage to your transmission.
A bad o2 sensor can cause this problem in a car. A bad fuel pump, fuel filter or fuel line will also cause hesitation during acceleration.
First you need to troubleshoot the 1994 LeSabre cruise control. Check the fuse, the cruise switch, the linkage, to find where the problem is. Check the vacuum lines on the engine as a vacuum leak can cause the cruise to not work properly.
check igntion coils
The catalytic converter on a 1994 Buick LeSabre can be removed to be replaced. It cannot be removed permanently from the vehicle. Removing the catalytic converter will cause the vehicle to not run properly because there are oxygen sensors attached to it that the car needs. Also, removing the catalytic converter permanently may violate state laws against pollution in some states.
Possibly the crank case oil sensor. Had the same symptoms on a Buick LeSabre '91
Serious. On the intake manifold a leak sucking in of air will cause a lean running condition generating excessive heat if the computer is unable to adjust by adding more gas to the mixture.
Possibly, if the collision was bad enough, more than likely though its a relay or fuse
Could be low brake fluid. Emergency brake could be partly on-make sure it is pulled completely in the up position.