Want this question answered?
need to adjust high speed jet in carberator, turn in all the way then back out about 1 turn out and go from there.
how to adjust petrol air on mt3700
adjustment screw is between throttlre linkage and carb body on the right side of the carb as you stand at the front of the car looking at the carb
The carburetor on a 330 Homelite chainsaw can be adjusted with the 3 screws. Turning to the right increases the richness or gas flow. Turning to the left increases the air into the mixture.
A wrench "by law", that a home owner is not allowed to buy.
turn both hi and low fully clockwise till seated. then turn each 1 full turn counterclockwise then adjust your idle speed with idle set screw.
Use the idle speed adjustment screw to set the idle speed as low as possible without stalling. http://store.chainsawr.com/
The pointed end of the idle speed screw should be centered on the idle arm on the carburetor. http://store.chainsawr.com/
Use the idle speed adjustment screw to set the idle speed as low as possible without stalling. http://store.chainsawr.com/
Remove the deck from the tractor, then remove both blades. They can be sharpened using a grinder. If you don't have a grinder, then there are shops out there that can sharpen them for you (try asking at a shop that sharpens chainsaw chains).
Not so sure it is. The manual shows none. If it suffers from reduced flow, the oil pickup may need to be checked for clogging. See link to manual, now a part of Husqvarna.
If it a Rochester carberator, there is no mixture adjustment. That is an internal setting done when the carburetor was put together or at the time of rebuilding. The only adjustments you can make is to the idle and choke I have a 93' 2500 vandura and It failed smog and I advanced the Timing a tiny bit and it passed....yaaaaay