0
What else can I help you with?
How do you remove the rear drive shaft from a 2000 grand Cherokee Laredo?
Use a crayon or piece of chalk and draw a line on the rear yoke in the differential and on the driveshaft. Do this on the front end of the driveshaft/trany/transfercase also. This is so the driveshaft goes back into the same position you took it from (otherwise you may get a vibration). Undo the 4 bolts on the rear axel yoke. Pry out universal from the yoke. Pull the driveshaft out of the back of the trany/transfer case. You may loose fluid from the trany/transfer case rear seal so check it when you reinstall it
Can you put differential fluid in the transfer case in a 1998 Jeep Grand Cherokee?
No, use ATF only.
How do you remove a 1999 Mitsubishi Eclipse GSX transfer case?
In a nutshell: Unbolt 4 nuts/bolts from rear of driveshaft from rear differential. Pull driveshaft out of transfercase. Unbolt driveshaft's carrier bearing from chassis. Unbolt and pull transfer case off of transmission. I'm in the process of doing an AWD swap into my Spyder now ! :) IHTH Brian
What is the function of an u joint in a car?
The u-joint (universal joint) allows the driveshaft to transfer power from the transmission to the differential during constantly changing angles.
Where is the front driveshaft on a 1995 ford explorer?
It connects to the transfer case just behind the transmission, and at the other end connects to the front differential, in between the front wheels. The front driveshaft is on the driver's side of the truck, about 1 1/2 feet from the center of the truck.
How do you disable four wheel drive in a 1995 jeep grand Cherokee?
To permanently disable, remove the drive shaft from the transfer case to the front differential.
Where is he driveshaft?
the driveshaft is the tube that runs from the rear of the transmission or transfer case if it has 4x4 and runs to the rear axle.
Can you swap a 2001 Jeep Grand Cherokee rear differential from Dana select track 3.73 ratio to Dana quadra track 3.73 ratio easily?
Why would you need to? The rear differential will be the same, only the transfer case will be different. :)
How replace Front driveshaft Chevy Astro van?
If your speaking of the actual driveshaft from the transfer case to the front differential, there are four torx head bolts to remove on each end of the shaft, if you mean how do you fix the shaft when the truck vibrates insanely, you either purcahase a completely new shaft or take your old one to a driveshaft shop and they can make you a new one with replaceable u-joints. hope this helps
What is a drive part on a tractor?
Conventional drive, your drivetrain will be the engine, transmission, transfer case (if 4x4), driveshaft(s), differential, and axles. Hydrostatic drive, it's going to use a hydrostatic transmission and hydraulic motors to drive the wheels.
2002 suburban flex fuel sensor location?
It is located next to the driveshaft that goes from the front differential to the transfer case (on a 4wd obviously). Specifically, it is just in front of the transfer case, on the drivers side of the driveshaft, mounted on a bracket on the frame. I found mine by going to the library and accessing the online automotive service manuals, which have more information than my Haynes service manual. This same online manual has a removal and installation procedure.
How do you know if your 1997 ford exployer xlt is 2WD or AWD?
On a 1997 Ford Explorer : The all wheel drive systemwas only availablewith the 5.0 litre / 302 cubic inch V8 and has a transfer case bolted to the back of the transmission and a driveshaft leading to the front differential The Control Trac 4x4 system ( or rear wheel drive ) was used with the 4.0 litre , V6 engine . The Control Trac 4x4 system has a LOW RANGE and the rotary selector dial is in the center stack of the dash just to theleft of the radio . It also has a transfer case bolted to the rear of the transmission and a driveshaft to the front differential
