no it did not
Ford was rather late in the mini-van game when they added the second sliding door in 1999, and continued it to the end of the Windstar name in 2003. Trivia Tidbit: The successor to the Windstar name was the "Freestar" and coincided with the introduction of the twin Mercury Monterey. I do not believe any single side door Windstar was offered after 1998.
It is very very likely the doors are interchangeable. The 1999 through 2003 Windstars were essentially unchanged.
Each sliding door has their own motor. Disconnect the wiring to the little motor inside the door you want disabled.
There is a child safety lock on the door itself,could be on the front end of sliding door too.not really sure though but good luck on that prob.
The passenger sliding door of a Ford Windstar LX needs frequent cleaning and checking of the rubbers to prevent jamming. If a door jams a lot during sliding, take out the rubber linings and clean them up before re-attaching.
Turn the door switch located at the front of the overhead console to off.
The 2001 Owners Manual shows fuses #110 (RH door) and #118 (LH door).Very likely these fuses apply to 1999-2003 Windstars
The Ford Windstar sliding passenger door has adjustments on the roller guides. There are roller guides on the top and the bottom of the door. There are also adjustments on the stationary door latch.
On a 1999 Ford Windstar : Open the drivers door and on the latch pillar you will see an information sticker . One of the things the sticker shows is the original size of tires on the vehicle from the factory
frame probably bent. Take it to a body shop or, better yet, replace the whole thing!!!
check the striker plate may need to be replaced or tightened
you have to just keep trying to open it
I had the same problem seems that the tumblers for the lock were seised up took it in to get it fix an was out in 15 mins.
locate unlock code on a 95 ford windstar
I believe there is a sticker on the drivers door (near the latch) with this info, also it may be in the owners manual.
There adjustable bolts holding your sliding door at the top and bottom. They maybe loose or the door may require adjusting. It's an easy fix.
check that the door contact switches are not grounding against the frame... good luck dave
Your door lock actuator is faulty and needs to be replaced
If the door is rattling while driving you may need to replace the plastic insulator. Open the door and check the rolling bearing at the bottom.
The engine may be reliable but there have been too many problems with power window switches,electric motors, power sliding doors and door ajar warning lights.
door catches on a latch partly open how can it be repaired
If you are having any heating or a/c issues in your Windstar, be sure to check your blend door for functionality FIRST. The most common issue with heat or A/C in the late model Ford windstar is a broken blend door. A broken blend door actuator is almost as common as a broken blend door itself. Typically, the fix requires disassembling the entire dash and replacing the whole plenum box, which can be a costly repair.
With the door open loosen the three bolts that hold the rear of the door onto the arm. Find out if it is striking high or low and gently move the door in the right direction a little bit at a time. Also check the bottom track for any obstructions.