0
When tightening a ball joint to a control arm how much torque is needed?
Wiki User
∙ 11y ago
55 Ft. Lbs
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
What are the torque specifications for tightening a CV joint on a 1994 Chrysler LeBaron?
the only thing to tighten is the spindle nut and i think that was 125 ft/lbs.
Is the Torque to fasten the same to unfasten?
The torque needed to loosen a bolt or joint is often much higher than the torque needed to put the bolt in in the first place. There is no set value difference between the two, unfortunately.
Is the torque increased decreased or constant on a universal joint?
is the torque increased decreased or constant
Which series you joint has the greatest torque capacity?
1480
How to fix water leaking from shower tube joint?
Usually this is just a matter of changing the rubber washer. This joint should only require hand tightening.
What is the torque specification for the lower ball joint on a 2001 Honda accord dx?
The 2001 Honda Accord lower ball joint torque specification is 90 pounds. The lower ball joint should be torqued in 45 pound intervals.
What is the torque setting for the lower ball joint on a Oldsmobile 88?
What year is the oldsmobile?, and do you need the torque setting for the nut?.
How do you replace axles 1991 Honda Accord AT?
Support vehicle properly on jack stands. Remove both front wheels. Remove lower ball joint nut and cotter pin. Remove axle nut (36MM). Seperate lower ball joint carefully. Pull axle from housing and from transmission. Reassemble in reverse order. Torque Axle nut to 105 ft./lbs Install new cotter pin in lower ball joint after tightening nut. Torque wheels to 80 ft.lbs. Drive away a happy Honda owner.
What is the torque spec for the ball joint?
on f150 19998 stud nuts
Who has exclusive authority direction and control of the Joint Staff?
The Chairman of the Joint Chiefs of Staff has exclusive authority, direction, and control of the Joint Staff.
Lower ball joints on a 1989 delta 88?
Raise and support the vehicle and place jackstands under the cradle. Vehicle weight should not be placed on the control arms.Remove the wheel assembly.Install drive axle boot protectors.Remove the cotter key from the ball joint nut and, using a ball joint removal tool, separate the ball joint from the steering knuckle.Drill out the ball joint retaining rivets. It may be necessary to chisel the drilled out rivets out of the control arm, even after drilling them "out."Remove the stabilizer bar bushing to control arm bolt.Pull the control arm downward and remove the ball joint from the steering knuckle and control arm.Reverse procedure to install. Torque the new ball joint attaching nuts to 50 ft lbs . The ball joint stud nut should be torqued to specifications, about 64 ft lbs.
Why atleast two muscles needed to move any joint in the body......?
Two muscles are not needed to move a joint but a bone attached to a joint in 2 opposite directions .
