Want this question answered?
At the bottom of the radiator there is a radiator hose that goes up to the engine. The hose runs into a housing with two bolts. Remove the two small bolts and the thermostat is inside.
Turn counterclockwise while pulling out.
located at the end of the upper radiator hose. remove two bolts, replace with new parts remember to replace the gasket.
Should be secured by bolts in each corner of seat
There is bolts under the hood and also in the door jamb
Bottom of the radiator.
on the bottom left corner of the front of the engine there is a hose coming from the radiator. AFTER DRAINING THE RADIATOR take the hose loose on the engine side, then remove the bolts the are around the place you just took the hose from. Inside there is the thermostat.
Remove the top and bottom radiator hoses including the transmission fluid, then remove the side mounting bolts, after that is completed, slide the radiator up and out of the engine compartment
how to remove lighter socket from 2013 dodge durango console
If you look down on the radiator, on the left side, there is a larrge hose coming out of the radiator toward the engine. Where the hose ends there is a housing with 2 bolts. The Thermostat is found under that. Remove the 2 bolts an replace the thermostat. Unles your arms are very long and thin, you will probably need to do this from under the car.
not to bad to change. Drain radiator, remove both radiator hoses, overflow jug disconnect cooling fan canon plug. leave fan on radiator. I think there is 4 bolts that hold radiator in, remove and remove radiator.
Should be at the lower left corner of the radiator.