right side of block behind starter
It is located behind the intake on top of the engine. It is not the same thing as a Crankshaft Position sensor. Don't get the 2 confused. The Crankshaft position sensor is located behind the starter on the housing for the torque converter. The camshaft position sensor is harder to get at which is why many mechanics will try everything else before they check this sensor. In some cases the engine may have to be removed, especially if a unskilled mechanic tries to remove it and breaks it off. Make sure to use extreme care when removing it.
on a 5.3L it is behind the starter that must be removed first
I have been having problems with finding the crankshaft sensor, what should i do or what can i do?
Under the distributor cap.
yes, under the rotor in the distributor
front of engine, behind the harmonic balancer
Knock sensor for the GMC Yukon is beneth the intake manifold mounted to the cam cover.
The cam sensor is located inside the distruberator and is held in place by two 15 torx screws. I just replaced the one in my 1997 Yukon and Auto Zone showed it on the timing cover but they were wrong It is a DR188 wells number
open your owner manual and you will find the answer.
Right on the top of the engine.
Right on the bottom of the engine just after the fan shroud. You can see it, it is visible without removing anything.
Speed o meter stop working need to replace speed sensor. Need to fine the location of sensor on a G M C Yukon 2003
The Klondike is a region of the territory of Yukon. So the Klondike is located in the Yukon.
For the exact location of the knock sensor, check your owners manual. There should be a diagram of the engine and all parts.
Right below the crankshaft.
IAT stands for the Intake Air temperature sensor. It is usually located in the air filter box or on the snorkle going to the throttle body
The Yukon is located in Alaska and two Provinces in Canada.
Yukon River is located in North America.
The crank position sensor (for the Chevy Tahoe/Suburban/GMC Yukon/Full size trucks) is located near the back of the engine block, on the passenger side. Near the starter. Note - the crank sensor (as well as the cam sensor) can occasionally leak oil and drip down, making it appear to be a rear main seal leak. If you have a leak at the bell housing, don't automatically assume a rear main leak.
In the Territory of the Yukon
the Yukon territory is on the northern located in Canada.
Yukon is located in the northwest corner of Canada, bordering Alaska
The sensor is located under the intake manifold. It takes about 2 and half hours to replace the intake manifold, book time. Knock sensor is about $35 + $60-$90/hr labor. So you are talking about $300.
The Yukon is located in north western Canada on the North American continent.