Buick LeSabre
Chevy Blazer S-10
Ford F-150

Where are the freeze plugs on a 1993 Buick Lesabre?

505152

Top Answer
User Avatar
Wiki User
Answered
2005-04-10 13:22:09
2005-04-10 13:22:09

In the sides and rear of the block.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


After alot of time and searching it has come up with a 1993 buick la sabre has a total of four freeze plugs on it and are very easy to get to and change.

where do the thermostat go in my 93 buick lesabre

The weight of a 1993 Buick Lesabre is approximately 3,340 lbs. The Lesabre has seating for six passengers to ride comfortably.

The 1993 Buick LeSabre Limited 4 door sedan has a curb weight of 3,454 lbs.

You did not mention if it was the intake to the cylinder head bolts (1993 buick lesabre 96 in-lbs)..... or ..... the intake upper to lower bolts ( 1993 buick 132 in -lbs) but i hope you will know wich you are looking at since there is a large difference in torqe.

Yea, the 1993 Buick Lesabre does have a fuse for the horn. However, there could be other reasons why the horn doesn't work, the clockspring or relay could be out.

yes, you can, i go to a technical college and my friends and i are going to supercharge my 93 buick lesabre over the summer..... and by the way, the 1993 buick park avenue is basically just the buick lesaber but it is super charged and with a nicer interior and additional aspects that are better.

How do you replace fuel filter on 1993 Buick LeSabre, the replacement filter I bought appears to be a snap on. I have only replaced the screw on type.

About 19 mpg in the city and about 28 mpg on the highway.

I believe most cars are scheduled @ 60k

The fuel tank capacity is 68 liters/18 Gallons.

Located in fuel tank - remove tank to access

under the front of the engine about center of the engine. hope this helps

check under car at the passenger rear door .

It should be located on the intake manifold by the distibutorless ignition module. On my 92 Lesabre it is located near the plugs at the back of the motor. On my 94 LeSabre it is located on the front/driver's side of the engine. There is a 4-wire connector on the top and it is mounted by two bolts on a flange. About 2" in diameter, 4" high.

My 1993 buick lesabre rims fit perfectly on my dad's 96 ford ranger, so I would have to say yes.

The resitor is probably burnt out on the high mode

Bottom of engine, passenger side, next to CV joint.

directly on top of the throttle body intake


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.