Both spee sensors are located under the car on the drivers side and right behind the tranny dip stick (looking from drivers side). There are 2 beige plastic plugs that screw directly into the tranny and wires attached to each. If you jack your car up and get under there with a flash lite you won't miss 'em.
Best of Luck
where is the input and output speed sensors located on a 2002 Dodge Intrepid?is that way the speedometer don't work?Read more: How_many_and_where_are_the_input_and_output_speed_sensors_located_on_a_2000_Dodge_Intrepid
the input and output speed sensors are on th driver side of the transmission located one on each side of the dipstick
The three sensors are [input sensors] that are wired to the Transmission Controller to give speed information to the Controller for proper shift points,[up-shifts-down shifts Input Turbine Speed.... Output Turbine Speed.. Vehicle Speed sensor...
AnswerTry replacing the input and output speed sensors located on the left side of the tranny and reset the computer. They will run around $40 to $50.
They are on the driver's side of the transmission, and require a 1 inch deepwell socket to remove, and you may need some extensions to reach it.
The input sensor reads the speed of the transmission input shaft.The output sensor reads the speed of the transmission output shaft.The transmission computer uses these sensors to help time the shifts, and to run the speedometer.The input sensor reads the speed of the transmission input shaft.The output sensor reads the speed of the transmission output shaft.The transmission computer uses these sensors to help time the shifts, and to run the speedometer.
There is one of each and they are located on the left (or driver's side) of the transmission. The front one is the input sensor right by the dipstick tube, and the rear one is the output sensor. Must be careful when tightening the new ones since the are plastic.
The input and output speed sensors are on the front of the transmission case. Both are two wire sensors. The input is closer to the engine.
The input and output speed sensors are the two wire sensors on the front of the transmission case. The input is closer to the engine.
There is no input speed sensor. The output sensor is located on the driver side rear of the auto trans case.
They read the speed of the input and output components of the transmission.
It is an input, sensors are always inputs.